Dell E2424HS Teardown Manual

Teardown report

Hide thumbs Also See for E2424HS:

Download this manual

1.Remove Rear Cover Screws and Stand

Screws

a. Remove screws "1~6" on the rear cover

with an electric screwdriver

b. Torque: 12.0 +/- 0.5Kgf/cm, Phillips

screwdriver

2.Remove Rear Cover

a. Pry off the back cover of the machine with

the aid of the dismantling fixture, in the

sequence of "Bottom->Left/Right->Top

3. Separate Rear Cover

a. Lift the rear cover

b. Remove acetate cloth tape marked with 1

c. Remove speaker cable marked with 2

E2424HS Teardown report

4. Remove speaker

a. Remove speaker cable marked with 1-5

b. Remove the speaker from rear cover

5.Remove Light Bar and Keypad Cable:

a. Remove acetate cloth tape marked with "1",

then remove the light bar (grasp on the Pin then

pull it outwards)

b. Remove Keypad cable "2"

6. Remove VGA screw

a. Remove screws "1~2" with an electric

screwdriver

b. Torque: 4.5 +/- 0.5Kgf/cm, hex screwdriver

Need help?

Do you have a question about the E2424HS and is the answer not in the manual?

Page 1 E2424HS Teardown report 1.Remove Rear Cover Screws and Stand 4. Remove speaker Screws a. Remove speaker cable marked with 1-5 a. Remove screws “1~6” on the rear cover b. Remove the speaker from rear cover with an electric screwdriver b. Torque: 12.0 +/- 0.5Kgf/cm, Phillips screwdriver 2.Remove Rear Cover...
Page 2 E2424HS Teardown report 7. Remove Aluminium Foil 10. Remove PCBA 2 a. Remove aluminium tape marked 1,2 a. Remove the PI board and the IF board b. Remove tape marked 3 b. Separate the PI board from IF board 8. Remove Aluminium Foil and LVDS Cable 11.
Page 3 E2424HS Teardown report 13. Remove electrolyte capacitor 13. Remove bulk capacitor Remove the electrolyte capacitor lager Take out the solder from capacitor pin with a than 25mm in height (squared in red) soldering iron. from the printed circuit boards. b. Lift the bulk capacitor away from the power b.