Toshiba DVR610 - DVDr/ VCR Combo Service Manual page 14

Reference Notes
CAUTION 1: Locking Tabs (L-1) and (L-2) are fragile.
Be careful not to break them.
1-1. Release five Locking Tabs (L-1).
1-2. Release three Locking Tabs (L-2).
1-3. Disconnect Connector (CN1231), and remove
the Panel Front.
2. When reassembling, solder wire jumpers as shown
in Fig. D9.
3. Before installing the Deck Assembly, be sure to
place the pin of LD-SW on BOARD Main as shown
in Fig. D9. Then, install the Deck Assembly while
aligning the hole of Cam Gear with the pin of LD-
SW, the shaft of Cam Gear with the hole of LD-SW
as shown in Fig. D9.
4. The DVD Mechanism & DVD Main BOARD
Assembly is adjusted as a unit at factory.
Therefore, do not disassemble it.
Replace the DVD Mechanism & DVD Main
BOARD Assembly as a unit.
[1] Cover Top
(S-1)
(S-3)
[3] Front
Bracket
(L-1)
(S-2)
(L-1)
(L-2)
CN1231
(S-1)
(S-1)
Fig. D1
(S-3)
(S-4)
(L-1)
[2] Panel
Front
Fig. D2
(S-6)
CN101
CN901
Hook
*
[6] DVD
Mechanism
&
DVD Main
BOARD
Assembly
*
See Reference Notes 4.
1-6-2
(S-5)
[4] Jack Bracket
[5] BOARD
Front Jack
Jack Plate Earth
(S-6a) Mecha Plate
(S-6)
Earth R
CN701
[7] Dust
Cover
Fig. D3
(S-6)
(S-7)
Fig. D4
E9KGADC