Advertisement
Quick Links
Fitting the brackets
Use the single hole in the top of the bracket to fix to
the lintel (the 'ceiling' of the recess).
5cm
Fitting the blind
Align the rear inside lip of the
headrail with the rear hook of
the bracket.
The brackets offer two methods of installation:
Top-Fixing
Push the protruding lever on
the front of the bracket
backwards.
Use two screws through the back plate to mount
onto a facing surface (a wall or window frame)
5cm
The outermost brackets should be mounted at
least 5cm in from the ends of the blind. Any
remaining brackets can be spaced evenly across
the width of the blind.
Tilt the headrail up until
straight, then release the lever
to lock in the blind.
Installation Guide
Honeycomb Blinds
Face-Fixing
To release the blind from the
brackets, push the lever back
to release the front hook, then
tilt the headrail downwards.
Advertisement
Related Manuals for TUISS Honeycomb Blinds
Summary of Contents for TUISS Honeycomb Blinds
- Page 1 Installation Guide Honeycomb Blinds Fitting the brackets The brackets offer two methods of installation: Top-Fixing Face-Fixing Use the single hole in the top of the bracket to fix to Use two screws through the back plate to mount the lintel (the ‘ceiling’ of the recess).
- Page 2 Installation Guide Honeycomb Blinds Child Safety Cord Safety Cleat The safety cleat shall be installed as close to the headrail as possible and in all cases not less than 1500mm from the floor. The cord must be fully accumulated around the safety cleat(s) when the blind is not in use. Use the table below to determine the distance required between the cleats to fully accumulate the cords when the blind is fully raised.
Need help?
Do you have a question about the Honeycomb Blinds and is the answer not in the manual?
Questions and answers