Initial Settings - Pioneer CLD-V2400 Programmer's Reference Manual

Chapter Four • CLD-V2600 / 2400 Level I & III

4.3 Initial Settings

The internal registers and switches are set to the following conditions when power
is turned on. The settings are not re-initialized when the player is put into Park or
Door Open Mode. Do not forget to set them to the parameters needed when creating
an application program. Some of the switch settings can be set only via Register
Commands under computer control; others can be set by using the DIP Switches
on the rear panel of the player or via Registers. For more information see Section
4.7.6 Register Control Commands, page 4-39, and Section 2.4 Function
Switch Settings, page 2-13.
Register/Switch
Key lock
Video switch
Audio switch
Display switch
Address flag
Speed parameter
Communication
Control
REG. A
REG. B
REG. C
Figure 4-D
4-4
TP 117
Initial Setting
0
1
7
0
3
60
Mode 3
3
0
1
CLD-V2600 / 2400 Level I & III User's Manual
v. 2.0 • 12/93
Status
Unlocked
ON
Digital Stereo
(If digital audio is
encoded on the disc.)
OFF
Frame - CAV; Time - CLV
Track - CD, CDV
Normal (X1) speed
Automatic Status
Frame/Chapter - LD;
Track/Time - CD, CDV
Normal squelch
Side Repeat ON and Blue
Squelch. (Load Start, Power
On Start and BAUD Rate can
be set using SW 1 & 2 on the
players' back panel. Squelch
color of Blue or Black can
be selected with SW 3 on the
back of the CLD-V2600).
These options can also be set
through Register C under
Level III control.