Related Manuals for RedLINK GO G450 Series
Summary of Contents for RedLINK GO G450 Series
- Page 1 S e p te m b e r 2 02 3 Q S G 1 _ A _ E N Quick Start Guide Apply to: Go Series G450 @ R e o l i n kTe c h h t t p s ://re o l i n k . c o m 58 .
-
Page 2: Table Of Contents
Content What's in the Box What's in the Box · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · 2 Camera Introduction ·... -
Page 3: Camera Introduction
Nano SIM Nano SIM Nano SIM MicroSD MicroSD MicroSD Camera Introduction Set up the Camera Activate SIM Card for the Camera Lens Nano SIM Daylight Sensor • Choose a Nano SIM card that supports WCDMA and FDD LTE. MicroSD Built-in PIR Sensor •... - Page 4 Nano SIM Nano SIM Register the SIM Card MicroSD MicroSD Nano SIM Nano SIM Nano SIM Nano SIM Nano SIM Nano SIM Nano SIM Nano SIM MicroSD MicroSD MicroSD MicroSD MicroSD MicroSD MicroSD MicroSD Nano SIM Nano SIM Nano SIM Nano SIM Nano SIM Nano SIM...
- Page 5 Nano SIM Nano SIM MicroSD Set up the Camera on the Phone Step 3 MicroSD Launch the Reolink App, click the “ ” button in the top right corner to add the camera. Scan the QR code on the device and follow the onscreen instructions to finish initial setup. Step 1 Scan to download the Reolink App from the App Store or Google Play store.
-
Page 6: Charge The Camera
Charge the Camera NOTE: You may also run into the following situations: Voice Prompt Camera Status Solutions It’s recommended to fully charge the camera before installing it. 1. Check if the SIM card is facing “SIM card cannot be Camera cannot recognize the reverse direction. -
Page 7: Install The Camera
Install the Camera Install the Camera on a Surface •For better motion detection performance, it is recommended to position the camera perpendicular to the expected movement of wildlife. • It is recommended to install the camera about 2 meters (7ft) above the ground to maximize the detection range of the PIR motion sensor. - Page 8 Install the Camera with Loop Strap Put the camera into the bracket, make Thread the provided strap through the bracket and fasten it to a tree. sure that the hole on the bracket aligns with the antenna post and the charging port, as shown in the picture.
-
Page 9: Safety Instructions Of Battery Usage
Safety Instructions of Battery Usage Troubleshooting sure it’s set up properly. • Make sure the battery is working. • Reset the camera and try again. Camera is not Powering On The camera is not designed for running 24/7 at full capacity or around-the-clock live streaming. -
Page 10: Specifications
or television reception, which can be determined by turning the equipment off If these won’t work, please contact Reolink FCC Compliance Statement and on, the user is encouraged to try to Correct Disposal of This Product Support. correct the interference by one or more of This device complies with Part 15 of the the following measures: FCC Rules. - Page 11 camera to factory default settings and take out the L’émetteur/récepteur exempt de licence contenu dans le présent inserted SD card before returning. appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio Simplifed EU Declaration of Terms and Privacy exempts de licence.
- Page 12 For EU: RF Power Frequency Technology From From UTRA Band I 1920 1980 21.95dBm UTRA Band VIII 22.05dBm E-UTRA Band 1 1920 1980 23.93dBm E-UTRA Band 3 1710 1785 24.60dBm E-UTRA Band 7 2500 2570 23.53dBm E-UTRA Band 8 24.24dBm E-UTRA Band 20 23.10dBm...
Need help?
Do you have a question about the GO G450 Series and is the answer not in the manual?
Questions and answers