Related Manuals for RedLINK Go Ranger PT
Summary of Contents for RedLINK Go Ranger PT
- Page 1 Q S G 1 _ A _ E N Quick Start Guide Apply to: Reolink Go Ranger PT @ R e o l i n kTe c h h t t p s ://re o l i n k . c o m...
-
Page 2: Table Of Contents
Content What's in the Box What's in the Box · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · 2 Camera Introduction ·... -
Page 3: Camera Introduction
Nano SIM Nano SIM Nano SIM MicroSD MicroSD MicroSD Camera Introduction Set up the Camera Activate SIM Card for the Camera Lens Nano SIM Daylight Sensor • Choose a Nano SIM card that supports WCDMA and FDD LTE. MicroSD Built-in PIR Sensor •... - Page 4 Nano SIM Nano SIM Register the SIM Card MicroSD MicroSD Nano SIM Nano SIM Nano SIM Nano SIM Nano SIM Nano SIM Nano SIM Nano SIM MicroSD MicroSD MicroSD MicroSD MicroSD MicroSD MicroSD MicroSD Nano SIM Nano SIM Nano SIM Nano SIM Nano SIM Nano SIM...
- Page 5 Nano SIM Nano SIM MicroSD Set up the Camera on the Phone Step 3 MicroSD Launch the Reolink App, click the “ ” button in the top right corner to add the camera. Scan the QR code on the device and follow the onscreen instructions to finish initial setup. Step 1 Scan to download the Reolink App from the App Store or Google Play store.
-
Page 6: Charge The Camera
Charge the Camera NOTE: You may also run into the following situations: Voice Prompt Camera Status Solutions It’s recommended to fully charge the camera before installing it. 1. Check if the SIM card is facing “SIM card cannot be Camera cannot recognize the reverse direction. -
Page 7: Install The Camera
Install the Camera Install the Camera on a Surface •For better motion detection performance, it is recommended to position the camera perpendicular to the expected movement of wildlife. • It is recommended to install the camera about 2 meters (7ft) above the ground to maximize the detection range of the PIR motion sensor. - Page 8 Install the Camera with Loop Strap Put the camera into the bracket, make Thread the provided strap through the bracket and fasten it to a tree. sure that the hole on the bracket aligns with the antenna post and the charging port, as shown in the picture.
-
Page 9: Safety Instructions Of Battery Usage
Safety Instructions of Battery Usage Troubleshooting sure it’s set up properly. • Make sure the battery is working. • Reset the camera and try again. Camera is not Powering On The camera is not designed for running 24/7 at full capacity or around-the-clock live streaming. -
Page 10: Specifications
If these won’t work, please contact Reolink FCC Compliance Statement or television reception, which can be Correct Disposal of This Product Support. determined by turning the equipment off This device complies with Part 15 of the and on, the user is encouraged to try to FCC Rules. - Page 11 camera to factory default settings and take out the inserted SD card before returning. Terms and Privacy Use of the product is subject to your agreement to the Terms of Service and Privacy Policy at reolink.com. Keep out of reach of children. End User License Agreement By using the Product Software that is embedded on the Reolink product, you agree to the terms of this End User License Agreement...
Need help?
Do you have a question about the Go Ranger PT and is the answer not in the manual?
Questions and answers