Network Setup; Wired Network Setup - Asus O!PLAY BDS-500 Owner's Manual

15
TV screen. Both sides of the pictures are cut off.
• 16:9 Wide - Select when a 16:9 wide TV is
connected. The 4:3 picture is adjusted
horizontally (in a linear proportion) to fill the
entire screen.
• 16:9 Wide Auto - Select when a 16:9 wide TV is
connected. The 4:3 picture is displayed with an
original 4:3 aspect ratio, with black bars
appearing at the left and right sides of the
pictures.
Note: Please refer to your display device
manual for the aspect ratios supported.
8. Select the audio setting and press Next.
• Primary Pass Through - if your audio output
device (i.e. amplifier) supports the pass through
function.
• PCM Multi Ch. - If your Pulse Code Modulation
(PCM) support Multiple Channel. See "Speaker
Setup (Under PCM Multi-channel mode)" on
page 36 for more information.
• PCM Stereo - Select this item if you connect this
unit's HDMI Out or Digital Audio Out jack to a
device with two-channel digital stereo decoder.
See "Audio Output Resolution" on page 35 for more
information.
9. Press OK to confirm your settings. Press
Previous to return to the previous menu.
The Home menu will show the screen shot below:

Network Setup

Wired Network Setup

If you have a DHCP (Dynamic Host Configuration
Protocol) server (can be a computer, router, access
point, etc.) on a LAN (Local Area Network), you
must configure it in order to use the wired network.
See your server's manual on how to configure it.
After you have finished the configuration, see page
12 for more information on network connection.
1. Use the navigation buttons and navigate to the
Setup menu and press OK.
2. Navigate to the Network menu and press
3. Select the IP Configuration and press
4. Select Wired and press OK.
5. A dialog box asking "The new setting resets the
existing one. Continue?". Press Yes to
continue.
6. In the "Wired IP configuration", you can choose
AUTO or Manual to set your setting. Press OK to
continue or Cancel.
7. Navigate to the Connection Status to view your
connection status.
→
.
→
.