JVC GY-DV300U - 1/3" 3-ccd Dv Camcorder Application Note page 2

1. Install Streamproducer on your media
server. The installation process is the
same as that of any Windows based
operating system. Refer to your User's
Guide for details. Please note that you
will need to reboot the server after
Streamproducer installation
2. If possible, t he cameras and servers'
network interface cards should be
configured with static IP addresses
since dynamic addresses are not
guaranteed to always be the same.
3. Open Streamproducer and connect to
the camera as shown in Application
Note 5, "Installing Streamproducer".
To determine a valid IP address, to use as a publishing
point for the server, open Streamproducer and click on the
'Connections' tab in the lower right corner. Select any
address you see in the window that is not in the same
network group as any cameras. For example, as shown
here, there are two addresses shown: 10. 0 .10.1:8080 (this
is in the same network group as our camera), or
206.229.18.130:8080 (this is the servers IP address, and is
the one we will use).
4. On the server, c lick 'Start', then 'Programs', then 'Tools',
and then 'Windows Media'. The following illustrations are
for Windows 2000 Server.
5. From the Windows Media Administrator, select 'Unicast
Publishing Points' as shown below.
? Page 2 of 4