Sanyo VPC CA6 - Xacti Camcorder - 6.0 MP Instruction Manual page 129

EDITING VIDEO CLIPS
5
Specify the start point of the extract.
h Use the procedure below to specify the frame from which the video
clip extract will start.
h Play the video clip until approximately the desired point, pause the
video clip, then play the video clip one frame at a time, stopping at the
start point of the extract. This will be the first frame of the extract.
h If the start point of the video clip is also the start point of the extract,
proceed to step 6.
<Procedure>
Play:
After pausing playback, press and hold the [H] button for about
2 seconds for forward playback, or the [G] button for reverse
playback.
Pause:
During playback, press the SET button.
Accelerated playback:
During playback, press the [G] or [H] button to change the playback
speed.
Single frame:
After pausing playback, press the [H] button to move forward one
frame, or the [G] button to move back one frame.
6
Press the [T] button.
h The start point of the video clip
extract is set, and the screen to
specify the end point appears.
h Specify the end point of the extract
by following the same procedure as
in step 5.
<When joining the first and latter
portions>
1 Press the [W] button.
h Each time the [W] button is
pressed, the sections to delete
and the sections to save are
reversed.
2 Specify the end point of the
extract. The frame following the
end point of the extract will be the
start point of the latter portion to
be joined.
113
English
Approximate playback time
CUT
Press shutter to save
Portion to be deleted
00:01:10
End point