Page 2
Should the reader have any questions or concerns which have not been satisfactorily addressed, please call, send an e-mail message, or write to the Technical Support Department for assistance. Phone: (800) 227-3172 E-mail: tech-support@hoshizaki.com 618 Highway 74 South Peachtree City, GA 30269 Attn: Technical Support Department Web Site: www.hoshizakiamerica.com...
Table of Contents Important Safety Information ............. 5 Know your Equipment ..............9 Check for Shipping Damage ............10 Handling the Cabinet ..............11 Location ..................11 Remove the Crate and Skid ............12 Level the Cabinet ................ 12 Electrical Installation ..............13 Shelves Installation ...
Important Safety Information Important Safety Information Throughout this manual, notices appear to bring your attention to situations which could result in death, serious injury, damage to the appliance, or damage to property. Indicates a hazardous situation that, if not avoided, will DANGER result in death or serious injury.
Page 6
WARNING This appliance should be destined only to the use for which it has been expressly conceived. Any other use should be considered improper and therefore dangerous. The manufacturer cannot be held responsible for injury or damage resulting from improper, incorrect, and unreasonable use. Failure to install, operate, and maintain the appliance in accordance with this manual will adversely affect safety, performance, component life, and warranty coverage.
Page 7
WARNING, continued • This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. •...
Page 8
WARNING, continued • Do not store gasoline or other flammable liquids or gases, near this or other electrical equipment. • Keep your fingers away from grills; the spaces between doors and cabinet are small, so be careful when closing doors when children are around. •...
Check for Shipping Damage Prior to leaving the factory, each cabinet is throughly inspected and performance tested to assure proper operating temperatures. Check the crate thoroughly for signs of shipping damage. If external damage exists, internal damage is also probable. Uncrating should be done while the carrier´s representative is present.
Handling the Cabinet 1. Always move the appliance in an upright position. Do not set it on its side or upside down as you may damage the cabinet and spill the compressor oil. 2. If lifting the appliance, hold it from its base. It is recommended to use a dolly. 3.
Remove the Crate and Skid 1. Remove the external packaging (corrugated board and plastic wrapping). Check for concealed damage. If any damage is identified, immediately forward a complaint to the transportation company. 2. Move the appliance to its final location, before removing the skid. 3.
Electrical Installation Electrical Connection WARNING • Electrical connection must meet national, state, and local electrical code requirements. Failure to meet these code requirements could result in death, electric shock, serious injury, fire, or severe damage to equipment. • This appliance requires an independent power supply of proper capacity.
Shelves Installation Shelves and shelf clips (4 clips per shelf) are packed inside the cabinet prior to shipment. After selecting the appropriate spacing inside the cabinet, install shelf clips by inserting top of clip inside the pilaster and then press the lower section of the clip while pushing inwards until it snaps into place.
Final Checklist 1. Is the appliance level? 2. Have the casters been properly installed and have the front casters been locked? 3. Is the appliance in a site where the ambient temperature is constantly within 45°F to 100°F (7°C to 38°C)? 4.
Installation of Trays and Separators 1. Remove the packaging from the trays and separators. 2. Open the lid. 3. Place the long separators according to the width of the transparent plastic tray.
Page 17
4. Place the short separators on top of the long separators according to the width of the transparent plastic tray. Left separator Middle separator Right separator 5. Arrange the trays. 6. Verify that the trays are installed correctly. Notes: It is recommended to keep the lid closed when not in use. The trays must always be installed while the equipment is in use, otherwise the evaporator may freeze or the appliance may not cool properly.
Controls and Adjustments Control module The position of the cabinet temperature control dial is preset to an appropriate temperature under normal conditions. To decrease temperature, move the cabinet temperature control dial to a higher number. To increase temperature, move the cabinet temperature control dial to a lower number.
Cleaning and Preventive Maintenance Your appliance requires very little maintenance. However, periodic cleaning can help maintain efficiency and prolong product life. Unplug the appliance from the electrical outlet bedore cleaning. Remove all products and place them in another pre-cooled appliance. 1.
Disposal DANGER FLAMMABLE • The appliance contains refrigerant and must be disposed of in accordance with applicable national, state, and local codes and regulations. Refrigerant must be recovered by properly certified service personnel. • The insulation foaming agent used for the unit body contains flammable gas cyclopentane.
Page 21
MAN-398-R-01 618 Hwy. 74 South, Peachtree City, GA 30269 USA (P) (800) 227-3172 www.hoshizakiamerica.com...
Need help?
Do you have a question about the VALIANCE VSR27A and is the answer not in the manual?
Questions and answers