Mackie D8B3.0 Owner's Manual page 41

Selects the AES/EBU digital input as the Control
Room source.
Selects the S/PDIF digital input as the Control
Room source.
Selects the main L-R output bus as the Control
Room source.
Combines the left and right channels to a
monaural signal and sends it to the left and right
Control Room outputs (Near Field or Main). This
provides for a quick check on the sound of the mix in
mono.
Turns on the Control Room Near Field output.
Turns on the Control Room Main output.
Note: The Near Field and Main speaker selections
cannot both be on at the same time.
• Adjusts the individual level of the selected
Control Room output (Near Field or Main).
• This control does not affect the level sent to
the Phones/Cue, or Master L-R mix
outputs.
• Near Field and Main levels are completely
independent of one another unless linked to-
gether in the Mix Options of the on-screen
Setup window.
• When linked, the level control is identical for
Near Field and Main. The link can be tempo-
rarily broken by pressing the Shift key and
adjusting the Speaker Level V-Pot. This is an
excellent way to set a fixed level offset between
monitor sets.
Quickly attenuates the control room monitors by
20 dB. This is very useful for phone calls or visits
from the neighborhood volume cop.
Routes the signal arriving at the in-panel
Talkback Mic to Phones/Cue Mixes 1 and 2 (and to
Studio Out if Talkback to Studio is selected).
Provides cut, copy, paste, and undo functions for
specific fader operations, channel parameters, and
automation events.
• Deletes edited parameters from the currently
selected channel(s) and returns them to their
default settings.
• Static or automated options are selected in the
Fat Channel display.
• The parameter settings are placed on the clip-
board for desired paste operations.
• Copies parameters from the currently selected
channel(s).
• Static or automated options are selected in the
Fat Channel display.
• The parameter settings are placed on the clip-
board for desired paste operations.
Pastes copied parameters to the currently
selected channels.
• Reverts the currently selected channels to their
previous status, before a cut, copy, or paste.
• Multiple Undo and Redo operations are avail-
able by pressing UNDO in the Clipboard
section then Undo and Redo in the control sur-
face Fat Channel VFD.