Download Print this page

Onset HOBO MX800 Series User Manual

Logger housing

Advertisement

Quick Links

HOBO
MX801 Logger Housing User Guide
®
Inside this package:
Logger housing
Mounting pin
2x O-rings for
logger
2x O-rings for 2-
sensor adapter
End cap
Installing the O-rings
1. Connect the sensor guard to the 2-sensor adapter. The sensor guard prevents damage to the sensors while
allowing ample water flow.
Note: A W-GUARD-2 anti-biofouling guard can be attached to the sensor guard to reduce biofouling. See
the
HOBO MX800 Two-Sensor Adapter (W-ADAPT-2) User Guide
2. Install two O-rings on the 2-sensor adapter by placing the assembly upright on a stable surface with the
sensor guard at the bottom. Slide the two O-rings into place using moderate force, ensuring they are
properly aligned and evenly seated into their respective grooves (see below).
3. Install two O-rings onto the MX801 logger (see above). The O-rings serve to stabilize and center each part
of the assembly.
Installing the Logger Housing
1. Before installing the MX801, ensure it is either configured, including the start mode, or awake for
HOBOconnect
configuration. Slide the protective logger housing over the logger then align the holes
®
on the logger housing with the locking-screw holes on the sensor guard.
2. Slide the end cap onto the logger housing (optional), ensuring the holes on the cap align with those
on the logger housing. The end cap provides additional protection and helps reduce fouling buildup
on the logger.
1-508-759-9500 (U.S. and International)
1-800-LOGGERS (U.S. only)
The logger housing provides
protection for the HOBO
MX801 Wireless Submersible
Data Logger when used with
the 2-sensor adapter (W-
ADAPT-2). This creates a
rugged assembly for mounting
on stakes, buoy lines, and
cement blocks.
1
Specifications
Materials
PVC
Stainless steel pin
Rubber O-rings
Weight
415 g (0.91 lb.)
Dimensions
26.2 cm x 7.1 cm
(10.3" X 2.8")
for more information.
www.onsetcomp.com

Advertisement

loading
Need help?

Need help?

Do you have a question about the HOBO MX800 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Onset HOBO MX800 Series

  • Page 1 HOBO MX801 Logger Housing User Guide ® Inside this package: The logger housing provides Specifications protection for the HOBO Materials Logger housing Stainless steel pin MX801 Wireless Submersible Mounting pin Rubber O-rings Data Logger when used with 2x O-rings for Weight 415 g (0.91 lb.) the 2-sensor adapter (W-...
  • Page 2 • HOBO MX800 Series User's Guide © 2014–2025 Onset Computer Corporation. All rights reserved. Onset, HOBO, and HOBOconnect are registered trademarks of Onset Computer Corporation. All other trademarks are the property of their respective companies. 1-508-759-9500 (U.S. and International) 1-800-LOGGERS (564-4377) (U.S. only)

This manual is also suitable for:

Hobo mx801