Download Print this page
Chauvet Cloud 9 Customer Manual
Chauvet Cloud 9 Customer Manual

Chauvet Cloud 9 Customer Manual

Low smoke generator

Advertisement

Quick Links

Customer Guide: Proper Maintenance of Cloud 9 Low Smoke Generator
Proper maintenance of your Chauvet Cloud 9 Smoke Machine ensures optimal performance.
Regular maintenance is key to prevent issues from occurring and to extend the life of the machine,
so please make sure to follow these steps for optimal performance.
1. Use the Correct Fluid and Quantity of Fluid:
Use Recommended Fluid: Use Only the Recommended Smoke Fluid Provided by Christie
Lites.
Use Adequate Fluid: Always ensure that adequate levels of fluid are in the machine during
operation to prevent damage to the pump and heater.
Temperature Consideration: Allow the Cloud 9 to heat up for about 4 minutes before use.
2. Be Mindful When Storing Fluid:
Fluid Tank Orientation: Always store the fluid tank with the cap facing upward to avoid
potential leakage or tube damage.
Overfilling: Do not overfill the distilled water tank beyond the maximum fill line, as this will
a,ect the performance. Drain any excess water before use.
3. Before Initial Use, Prepare the Machine Properly:
Initial Setup:
1. Clean the Machine: Before use, ensure the Cloud 9 is free of dust and debris. Clean the
machine if necessary.
2. Refill Fluids: Fill the fluid bottle with Fog Fluid and distilled water (approximately 20 liters).
3. Power Up: Turn on the machine and allow it to heat up for 20-30 minutes (depending on
ambient temperature).
Test the machine:
1. Turn on Full Output: Press the DOWN/VOLUME button to activate full output. If output is
weak, adjust the volume to check that it's functioning properly.
2. Stopping the Machine: Press the ENTER/STOP button. The machine may run for up to 10
seconds after stopping to clear itself.
3. Check DMX: If connected to DMX, check the display for the DMX address. The display
should show the address when the unit is receiving a DMX signal.
4. Priming: If the machine has been stored and output is low, ensure the fluid pipe is free of
air. The priming process may take some time. If no fluid is detected, the display will show

Advertisement

loading
Need help?

Need help?

Do you have a question about the Cloud 9 and is the answer not in the manual?

Questions and answers

Summary of Contents for Chauvet Cloud 9

  • Page 1 3. Before Initial Use, Prepare the Machine Properly: Initial Setup: 1. Clean the Machine: Before use, ensure the Cloud 9 is free of dust and debris. Clean the machine if necessary. 2. Refill Fluids: Fill the fluid bottle with Fog Fluid and distilled water (approximately 20 liters).
  • Page 2 5. Clean the Machine at Frequent Intervals To maintain performance and extend the life of your Cloud 9, clean it every 40 hours of continuous use. Chauvet recommend using Chauvet Cleaning Fluid (FCQ) if possible. Cleaning Procedure: 1.
  • Page 3 Avoid Operating Without Fluid: Never run the machine dry (without fluid) as this can • damage the pump. Do not use tap water: as it contains impurities that can damage the ultrasonic agitator. • Always use the approved fluid. Important Safety Note: Always follow the safety guidelines as shown in the user manual. Never operate the machine in poorly ventilated areas or close to heat sources and ensure smoke machine fluid is stored safely.