HOMCOM 800-254V70 Manual page 25

6. After 20 minutes of one self-cleaning program completing, pull out the drain
pipe of the water tank, drain the cleaning solution down to the lower ice
storage bin. Shakethe unit slightly to drain out all of the cleaning solution
completely. Then install back the drain pipe to the slot of the water tank.
Repeat steps 4--6 to clean the ice making assembly system again.
7.
The ice machine cleaner contains acids.
DO NOT use or mix with any other solvent-based cleaner
products.
Use rubber gloves to protect hands.
Carefully read the material safety instructions on the container
of the ice machine cleaner.
Then open the water faucet of the main water supply, Let the water flow in the
8.
unit. And press the"TIMER/CLEAN"button on control panel for more than 5
seconds, to enter the self-Cleaning program. Same as above explanation,
the water pump runs for 8 minutes and stops for 3 minutes, one cycle, again
one cycle. The total duration time is 20 minutes for one self-cleaning
program.
During this process, the "
and the digit window will indicate the left time. Through this process, It will
rinse the water dividing pipe, evaporator, water pump, silicone pipe, and
water tank, etc..
9. After one self-cleaning program complete, then pull out the drain pipe of the
water tank, drain the cleaning solution down to the lower ice storage bin,
also shake the unit slightly to drain out all of the water completely. Then
install back the drain pipe to the water tank slot tightly.
Repeat the step 8-9 again for 2 times.
10.
11. Following the above program to clean the ice storage bin .
12. Then this special cleaning program finish, you can return to the regular ice
making mode. And suggest to discard the first batch of ice cube.
Cleaning Suggestion
1) DAILY CLEANING
The ice shovel, door and the water dividing pipe should be cleaned by
yourself per each day. At the end of every day, rinse the ice shovel and
wipe the both sides of the door with a clean cloth.
2) SEMI-MONTHLY CLEANING
The ice shovel, ice bin, water tank, the ice-full detecting plate and the
surface of the evaporator are to be cleaned by yourself semi-monthly
according to interior cleaning program.
3) SEMI-ANNUAL CLEANING
All the components & surfaces exposed to water or ice cubes, like ice
storage bin, water tank, door, evaporator, water pump, silicone tube,
water dividing pipe, etc. should be cleaned
Nickle Safe Ice-machine Cleaner
be cleaned by the serviceman according to ice making assembly system
cleaning program.
"symbol will always be on during this period,
per each 6 months. They should
24
by Using Nu-Calgon