Cruise Control; Ultrasonic Rear Parking Assist; Turn/Lane Change Signals - Chevrolet CRUZE - 2011 Quick Reference Manual

Cruise Control

Setting Cruise Control
1. Press the On/Off button. The
Cruise Control symbol will illuminate in
white in the instrument cluster.
2. When traveling at the desired speed,
rotate the SET– switch down to set the
speed. The
will illuminate in green in the instrument
cluster.

Ultrasonic Rear Parking Assist

Detected objects are indicated by audible beeps when the vehicle is in Reverse. The
interval between beeps becomes shorter as the vehicle gets closer to an object. When the
distance is less than 12 in. (30cm), the beeps are continuous. The system operates only
at speeds less than 5 mph.
• To turn the system on/off, open the Collision Detection menu in the Vehicle Settings
menu by using the audio system controls.
• When the system is on, a beep sounds when shifting into Reverse.
Note: The system may be disabled if dirt, snow or ice builds up on the sensors. Keep the vehicle
clean for proper operation.

Turn/Lane Change Signals

• To signal a lane change, raise or lower the turn signal lever until the indicator arrow
starts to flash; then release the lever. The turn signal will flash automatically three
times.
• To signal a turn, raise or lower the lever all the way up or down.
12
Cruise Control symbol
Adjusting Cruise Control
RES+ Resume/Accelerate
Rotate the switch up to resume a set
speed.
When the system is active, rotate the
switch up to increase speed.
SET– Set/Coast
When the system is active, rotate the
switch down to decrease speed.
Cancel
Press to cancel the cruise control but
retain the set speed in memory.
Pressing the brake pedal or clutch pedal
(manual transmission only) also will cancel
the cruise control.
The cruise control set speed is erased
when cruise control or the vehicle ignition
is turned off.
See Driving and Operating in your Owner Manual.
✦
See Driving and Operating in your Owner Manual.
See Driving and Operating in your Owner Manual.