GET BOOST Manual

PRODUCT LAYOUT

GET BOOST INSTALLATION

REMEMBER TO OPERATE IN SAFE CONDITIONS AND KEEP THE ENGINE OFF.

1. Remove the seat and position the GET wiring under the frame crossmember, keeping the main connector (A) oriented towards the rear fender.
   
2. Insert the GET Boost module into the dedicated rubber mount provided in the kit. Connect the main GET wiring connector (A) to the GET Boost connector.
   
3. Locate the original relay under the seat. Without disconnecting or removing it from its rubber mount, detach the relay from its metal mounting tab. Install GET Boost in its place, fastening it to the original metal tab. Secure the relay to the GET Boost module with a zip tie.
   
4. Disconnect the original first injector connector.
   Connect the male B1 connector of the GET wiring to the original first injector connector.
   Connect the female B2 connector of the GET wiring to the original first injector.
   
5. Disconnect the original male and female connectors of the throttle body.
   Connect the male C1 connector of the GET wiring to the original female throttle body connector.
   Connect the female C2 connector of the GET wiring to the original male throttle body connector.
   
6. Attach the ground ring terminal D of the GET wiring to the external bolt of the chain tensioner on the cylinder.
   
7. Reinstall the seat.

WARNINGS FOR PROPER USE

Please carefully read all instructions and warnings before using the GET Boost Kit. Failure to read and/or follow the instructions and warnings may result in improper use or malfunction of the device, potentially causing product damage and personal injury.
THE GET BOOST KIT IS INTENDED FOR RACING USE ONLY.

GENERAL WARNINGS

1. Follow the instructions described in this manual to avoid damage to the vehicle.
2. Do not modify or replace any materials provided by GET.
3. Always ensure that no installed parts interfere with hot engine components, steering components, or the rider.
4. This product is not a toy. Keep it out of reach of children and pets as it contains small components that could be swallowed.
5. Do not use the product for purposes other than those specified in these instructions.
6. Do not use pressure washers on the product.

SPECIFIC WARNINGS

1. Always ensure that the GET Boost Kit is properly installed and functioning before using the motorcycle.
2. Never expose the device to temperatures above 70°C/158°F.
3. Install it when the engine is cold.
4. If the motorcycle does not start or the engine runs irregularly, verify that the motorcycle on which GET Boost is applied matches the make, model, and year specified by Athena in the list of compatible applications.
5. The GET Boost Kit included in this package works only on motorcycles with an original electrical system.

The GET Boost Kit enhances motorcycle performance once the new Athena Big Bore Cylinder Kit is installed.

Installing GET Boost without the correct Athena Big Bore Cylinder Kit may lead to anomalies or malfunctions of the motorcycle, potentially causing damage and personal injury.