Safety Regulations - Sony AITE260 - AIT E260/S Tape Drive Operating Instructions Manual

Safety Regulations

Owner's Record
Information
2
Safety Regulations
The model and serial numbers are located on the bottom. Record the serial
number in the space provided below.
Refer to them whenever you call upon your dealer regarding this product.
Model No.
________________________
WARNING
To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture.
To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
Model No. for Regulatory Compliance
Your AITe1040 or AITe1040V is assigned a Model No. SDX-D1100 for
regulatory compliance certifications. Your AITe520, AITe520V, AITe390, or
AITe390V is assigned a Model No. ATDEA4 for regulatory compliance
certifications. Your AITe260 or AITe260V is assigned a Model No.:
ATDEA3 for regulatory compliance certifications. Your AITe130,
AITe130V, AITe90, or AITe90V is assigned a Model No.: ATDEA2 for
regulatory compliance certifications. The number is indicated on the model
number label on your drive along with the rated voltage and current.
For the customers in the USA
You are cautioned that any changes or modifications not expressly approved
in this manual could void your authority to operate this equipment.
WARNING
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
All interface cables used to connect peripherals must be shielded in order to
comply with the limits for a digital device pursuant to Subpart B of Part 15 of
FCC Rules.
Serial No.
__________________________________