How To Use The Appliance - GEHA Home & Office A3 BASIC Manual

HOW TO USE THE APPLIANCE

• We do not recommend laminating any type of self-developing photo.
• Any photo to be laminated must be dry before processing.
• Do not laminate any documents that appear thick or heavy, as they will get stuck in
the laminator. If this occurs, please contact your local service centre for servicing.
• This product bonds the laminate sleeve to the items processed. It is a permanent
seal and cannot be removed.
• We do not recommend laminating any collector's items of value or any item you
may wish to remove at a later date. Do not attempt to laminate coins or thicker items.
fig. 1
1. Activate the device by pushing the sliding switch to the right or left, depending on the
temperature required for the actual pouch thickness (fig. 2). The red indicator light is on.
2. When the blue light comes on, the machine is ready for hot pouches lamination (fig. 1).
The warm-up time takes approx. 3-5 minutes.
3. Place the item to be laminated into the laminating sleeve, centring it within the sleeve.
Please make sure your document or picture is positioned as close to the sealed edge
as possible.
• The laminator does not require the use of a carrier in order to operate.
• The laminator can laminate pouches from 80 microns to 125 microns.
It works with most types of heat-sealing laminating pouches.
4. Insert the sealed edge of the laminating sleeve straight into the CENTRE of the
laminator opening.
5. Remove the sleeve from the rear of the machine after is has stopped moving.
6. Some types of paper do not laminate evenly, or appear somewhat cloudy.
In such cases, the lamination can be fed through the machine a second time and
the lamination process may be repeated.
7. If there is a jam, please press the ABS button located on the top of the machine (fig. 1).
The laminator will stop then. Please pull out the laminating pouches with
one hand slowly.
8
fig. 2