Page 1
F18S10091 E L E C T R O N I C F L A S H EF-610 DG SUPER INSTRUCTIONS SA-STTL...
Page 2
ENGLISH The CE Mark is a Directive conformity mark of the European Community (EC).
Page 3
Otherwise it might cause fire or explosion. Caution !! Do not use this flash unit on any camera other than the Sigma SA, SD series cameras, otherwise the flash may damage the circuitry of these cameras. This flash unit is not waterproof. When using the flash and camera in the rain or snow or near water, keep it from getting wet.
DESCRIPTION OF THE PARTS 1.Flash Head 2.AF Auxiliary Light 3.Bounce Angle; Up and Down 4.Bounce Angle; Right and Left 5.Bounce Lock and Release Button; Up and Down EXTERNAL 6.Swivel Lock and Release Button; Right and Left 7.LCD Panel 8.Battery Cover PARTS 9.Shoe Ring 10.Shoe...
■ Depending on the flash head setting, the flash’s Guide Number will be changed. In the case of use with Sigma SD9 SD10 SD14 SD15 Due to the size of the camera’s image sensor, when the coverage angle of the flash is set to auto zoom, coverage angle can effectively reach that of 17mm wide focal length, without using the wide panel, (However, the coverage angle display of the flash will not show wider than 24mm).
In this case ◆ ZOOM please contact the store where the flash was purchased or a Sigma service station. LCD PANEL ILLUMINATION When you press the button, the LCD panel will illuminate for about 8 seconds. The illumination...
USING FLASH IN OTHER CAMERA MODES Shutter Speed Priority Setting By selecting the S mode of the camera, you can set the shutter speed from 30sec. to 1/X sync speed. When you set the desired shutter speed, the camera will select the appropriate aperture value for the background.
FP FLASH (Except SA-300) When you take a picture with an ordinary flash, you cannot use a shutter speed faster than the camera’s synchronized speed because the flash must fire when the shutter curtain is fully open. The FP flash keeps firing, while the shutter curtain is running. Thus you can use a shutter speed faster than the synchronized speed.
MODELING FLASH If useing the Modeling flash, you can check the lighting and shadow effects before taking the picture. 1. Press the MODE button and select the mode. 2. Press the + button or – button several times to make the icon on the LCD panel appear.
BOUNCE FLASH When you take a photo with flash in a room, sometimes a strong shadow will appear behind the subject, if you point the flash head upwards or sideways to reflect the light off the ceiling, wall etc. the subject will be illuminated softly.
Page 11
WHEN BUILT-IN FLASH IS USED (SA-7, SA-9 SD14 AND SD15) 1. Press the MODE button to select the mark. 2. Press the SEL button to make the channel indicator blink. 3. Press the + button or – button to set the channel. 4.
SLAVE FLASH NORMAL SLAVE FLASH Even if the EF-610 DG SUPER SA-STTL is not attached to the camera body, you can fire the flash by using the camera’s built-in flash or another flash unit. 1. Attach the flash unit to the camera’s hot shoe. 2.
3. Switch “ON” the flash unit and press the camera’s shutter button halfway. (The aperture value and film speed are now automatically transmitted to the slave flash unit.) 4. Remove the slave flash unit from the camera. 5. Press the MODE button and select the .
Page 15
Disposal Electric Electronic Equipment Private Households ENGLISHsposal of used Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product, in the manual/warranty, and/or on the packaging indicates that this product must not be treated as household waste.