F-SECURE LINUX SECURITY Manual page 76

76 | F-Secure Linux Security | Troubleshooting
I get reports that "F-Secure Status Daemon is not running", how can I start it?
Sometimes, after a hard reset for example, F-Secure Status Daemon may fail to start. Restart
the product to solve the issue:
/etc/init.d/fsma restart
.
Alternatively, you may start F-Secure Status Deamon manually:
/opt/f-secure/fsav/bin/fstatusd
I need to compile kernel drivers manually, how do I do that?
You may need to compile kernel drivers that the product need manually, if
• you did not have compilers and other required tools intalled during the installation,
• you did not have kernel headers or sources installed during the installation, or
• you have upgraded the kernel and you need to compile drivers for the new kernel.
To compile and install drivers, run the following command:
/opt/f-secure/fsav/bin/fsav-compile-drivers