Tiger ETCB User Manual

Download this manual

This hoist should not be installed, operated or maintained by any person who has not

read all the contents of these General Instructions. Failure to read and comply with

of the limitation noted herein can result in serious bodily injury and / or property

IMPORTANT REMARKS FOR ETCB

1) Never use electric or air – " Impact drivers".

2) We suggest to use the drill of maximum 2500 rpm to operate this unit.

3) We recommend at least 18V

brand/models of drill as below: (Makita / DDF486Z, Makita / DF001GZ )

If using a cordless drill, we also recommend to prepare a spare battery.

5) Before moving the ETCB, be sure to remove any drill from the Hoist.

WARNING

these instruction or any one

damage.

ETCB

ETCB-0300 / ETCB-0600

User Manual

(cordless

drill), minimum: 500W and suggest to use the

(2023 v.1)

Need help?

Do you have a question about the ETCB and is the answer not in the manual?

Page 1 500W and suggest to use the brand/models of drill as below: (Makita / DDF486Z, Makita / DF001GZ ) If using a cordless drill, we also recommend to prepare a spare battery. 5) Before moving the ETCB, be sure to remove any drill from the Hoist.
Page 2 MODEL NO: ETCB-0300 / ETCB-0600 Part No. Quantity Part Name Part No. Quantity Part Name Part No. Quantity Part Name Label Chain-End-Fixing Pin Ratchet Gear Ring (ETCB) M12 Nut Load Chain Anchoring Bottom Hook Assembly Bottom Hook Pin Gear Cover...
Page 3 1 IMPORTANT REMARKS FOR OPERATORS INSPECTION Do not give the load a sudden take-off. Take a breath when the load chain is just taut, and check for brake action by pulling up and down about Do not overload your chain hoist. 10cm above floor.
Page 4 63.5 be replaced immediately. 5 ALIGNMENT OF GEARS DURING REASSEMBLY Model No.: ETCB-0300﹐ETCB-0600 Notice the marks " 0 " on the gears, place " 0 " mark face to sheave on horizontal centerline on right side , place the other" 0 " mark face to up direction on vertical centerline on left side as shown.

Etcb-0300Etcb-0600