REPLACING A DIXELL THERMOSTAT WITH A DANFOSS THERMOSTAT
1.
Unplug the unit from the receptacle.
2.
Remove the screws that are holding the thermostat housing to the front of the unit, and then remove the Dixell
thermostat from the housing.
3.
Cut the wires off the old harness on the Dixell thermostat.
4.
Attach the yellow wire from the Danfoss thermostat to either the black wire with a red stripe or the yellow wire on the
harness.
5.
Attach the white wire from the Danfoss thermostat to the white wire on the harness.
6.
Attach the black wire from the Danfoss thermostat to the black and red wires on the harness.
7.
Replace the Dixell sensor with the Danfoss sensor that is provided and already attached to the Danfoss control.
8.
Reattach the thermostat housing to the unit and plug it back into the receptacle.
REPLACING A DANFOSS THERMOSTAT WITH A DANFOSS THERMOSTAT
1.
Remove the black, white, and yellow wires from the Wago quick connection points on the back of your current control.
2.
Remove the current Danfoss control and install the new one, ensuring that the wires supplied remain connected to the
control.
3.
Connect the black wire from the new Danfoss control to the Wago black wire connection point.
4.
Connect the white wire from the new Danfoss control to the Wago white wire connection point.
5.
Connect the yellow wire from the new Danfoss control to the Wago yellow wire connection point.
6.
To ensure accurate readings, we recommend replacing the current sensor with the new one.
7.
Reattach thermostat housing to unit and plug into receptacle.
1.
Cut the black, white, red and yellow wires from the old harness on the Dixell thermostat.
2.
Attach the yellow wire from the Danfoss thermostat to the yellow wire from the harness.
3.
Attach the white wire from the Danfoss thermostat to the white wire from the harness.
4.
Attach the black wire from the Danfoss thermostat to the black and red wires from the harness.
MICROMATIC.COM | 866-327-4159
REWIRING A DANFOSS THERMOSTAT INTO A CONTROL BOX
WITH A DIXELL THERMOSTAT
POWER PACK SERVICE MANUAL | 13
Need help?
Do you have a question about the Pro-Line MMPP4301-EP and is the answer not in the manual?