Related Manuals for Axis TA1101-B
Summary of Contents for Axis TA1101-B
- Page 1 AXISTA1101-BWiegandtoOSDP Converter AXIS TA1101-B Wiegand to OSDP Converter User manual...
-
Page 2: Table Of Contents
AXIS TA1101-B Wiegand to OSDP Converter Table of Contents Solution overview ............................3 Specifications..............................4 Product overview ............................4 LED indicators............................4 Buttons ..............................5 Control button ..........................5 Connectors .............................5 OSDP connector ..........................5 Wiegand connector...........................5 Supervised inputs ..........................6 DIP switch connector ........................6 Troubleshooting.............................8 Reset to factory default settings .......................8 ..............................8... -
Page 3: Solution Overview
AXIS TA1101-B Wiegand to OSDP Converter Solution overview The Wiegand to OSDP converter is used between the Wiegand reader and door controller to convert Wiegand data to OSDP. Each Wiegand reader must be connected to one converter. -
Page 4: Specifications
AXIS TA1101-B Wiegand to OSDP Converter Specifications Product overview 1 OSDP connector 2 Wiegand LED 3 OSDP LED 4 Case open tamper 5 Control button 6 Wiegand connector 7 DIP switch LED indicators OSDP LED Indication Blinks green Idle. No OSDP communication... -
Page 5: Buttons
AXIS TA1101-B Wiegand to OSDP Converter (On for 50 ms) Green Enter or exit the configuration mode (*) (On for 1s) Blinks green In the configuration mode (*) every 250 ms Wiegand output over current error (*) See . Buttons... -
Page 6: Supervised Inputs
Note Wiegand data isn’t encrypted. To reduce security risk, install the Wiegand reader as close as possible to AXIS TA1101-B when using OSDP Secure Channel. Supervised inputs To use supervised inputs, install end of line resistors according to the diagram below. - Page 7 AXIS TA1101-B Wiegand to OSDP Converter Description Address 0 (OSDP COMSET supported) Address 1 Address 2 Address 3 120 Ohm RS485 termination disabled 120 Ohm RS485 termination enabled Single Wiegand LED mode (LED1) Dual Wiegand LED mode (LED1 + LED2)
-
Page 8: Troubleshooting
• Preconfigured and customized settings are saved when you upgrade the device software (provided that the features are available in the new version) although this is not guaranteed by Axis Communications • Make sure the device remains connected to the power source throughout the upgrade process. -
Page 9: Contact Support
AXIS TA1101-B Wiegand to OSDP Converter Contact support If you need more help, go to axis.com/support. - Page 10 T10221892 2025-04 (M1.13) © 2025 Axis Communications AB...
Need help?
Do you have a question about the TA1101-B and is the answer not in the manual?
Questions and answers