Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for VADO ARRONDI ARR-132-CP
Summary of Contents for VADO ARRONDI ARR-132-CP
- Page 1 ARRONDI This installation guide covers model: ARR-132-CP Deck mounted 4 hole bath shower mixer ARR-232-CP Installation Guide ARR-132-CP ARR-232-CP VADO Wedmore Road Cheddar Somerset England BS27 3EB tel 01934 744466 fax 01934 744345 www.vado.com sales @ vado.com Version 1, 1-4-22...
-
Page 2: General Installation
Important - Please Read Contents of Packaging Please read these instructions carefully before starting installation and keep for future reference. Remove all packaging and check the product for missing parts or damage before starting installation. Any alterations made to this product and fittings may infringe water regulations and will invalidate the guarantee. -
Page 3: Valve Dimensions
Contents of Packaging Valve Dimensions 175mm 134mm Elbow Handset with washer Worktop tolerance 1-18mm 74mm 314mm 58mm Capsule Hoses with washers x 3 Waste adapters ½" Waste hose Diverter Spout Mixer Shower hose... - Page 4 Dimensions Overview Handset 400mm 45mm 48mm Spout Diverter Mixer Cold inlet Hot inlet Flexible hose from diverter to mixer Flexible hose from diverter to spout ½" BSP Flexible hose from diverter to shower via capsule 78mm 78mm Waste adaptors...
- Page 5 Installation - Quick Guide Installation - Quick Guide 80mm 80mm 80mm Ø30mm Ø48mm Ø30mm Ø48mm Ø48mm Ø30mm...
- Page 6 Installation - Quick Guide Installation - Quick Guide Ø48mm...
- Page 7 Installation - Quick Guide Installation - Quick Guide...
- Page 8 Installation - Temperature Control Installation - Spout Before installing, flush through Drill a 30mm diameter hole in the Spout 80mm 80mm 80mm the pipework to ensure removal of required position. Make sure the debris, turn off the water supply. O-ring is in place in the underside of the spout cover.
-
Page 9: Installation
Installation - Diverter Installation Drill a 48mm diameter hole Preparation in the required position. Before you start to install the Capsule you Handle Remove the handle connector will need to remove some of the fittings. lever from the concealed valve. Feed Unscrew the cover cap and remove the the diverter valve up through the inlet adaptor and washer at the bottom of... - Page 10 Installation Installation Remove the string Decide where to fit to the bath, it could go Fig 1 along the short or long edge, make sure Place the rubber washer over the adaptor. access can be gained to the underneath Insert the fibre washer into the adaptor, Escutcheon to connect water inlet, and be able to then fit and tighten the hose.
- Page 11 Installation - Waste Temperature Commissioning Note: mixed water temperature at terminal fitting should never exceed Stop ring Fig.1 Rubber 46°C. seal Waste Stop arm The valve has been factory set under adaptor Existing pop-up balance pressures and hot water supply waste fittings Existing at 65°C.
- Page 12 Notes: Notes:...
Need help?
Do you have a question about the ARRONDI ARR-132-CP and is the answer not in the manual?
Questions and answers