Chamberlain 041-0198 Replacement

Instructions
The images throughout this manual are for reference only and your product
may look different.
1. Disconnect electrical and battery power (A) (if applicable) to the garage door
opener. Remove battery and place in a safe location.
2. Remove the control door panel, twist at the hinges and place in a safe
location (B).
3. Remove the end panel (C).
• Remove the 2 screws on the bottom .
• Remove the 2 top inside screws.
4. Attach the provided blank label (D) to the new end panel and copy the
important product information from the original end panel label to the new
label.
5. Install the new end panel.
• Attach the 2 top inside screws.
• Attach the 2 screws on the bottom.
6. Reattach the control door panel.
7. Reconnect electrical and battery power (if applicable) to the garage door
opener.
8. Recycle the old end panel.
B
Replacement Label
D
Repair Parts 041-0198 and 041-0199
To prevent possible SERIOUS INJURY or DEATH:
• Disconnect ALL electric and battery power BEFORE performing ANY
service or maintenance.
ALWAYS wear protective gloves and eye protection when changing the
battery or working around the battery compartment.
WARNING: This product can expose you to chemicals including
lead, which are known to the State of California to cause cancer or
birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
A
C
End Panel Replacement