Set Supervisor Password; Set User Password - Gigabyte GA-2CEWH User Manual

GA-2CEWH Motherboard

Set Supervisor Password

You can install and change this options for the setup menus. Type the password up to 6
characters in lengh and press <Enter>. The password typed now will clear any previously
entered password from the CMOS memory. You will be asked to confirm the entered
password. Type the password again and press <Enter>. You may also press <Esc> to abort
the selection and not enter a specified password or press <Enter> key to disable this option.

Set User Password

You can only enter but do not have the right to change the options of the setup menus. When
you select this function, the following message will appear at the center of the screen to assist
you in creating a password.
Type the password up to 6 characters in lengh and press <Enter>. The password typed now
will clear any previously entered password from the CMOS memory. You will be asked to
confirm the entered password. Type the password again and press <Enter>. You may also
press <Esc> to abort the selection and not enter a specified password.
Password on boot
Password entering will be required when system on boot.
Enabled
Disabled
Start From Floppy
Enabled
Disabled
Start From IDE HDD
Enabled
Disabled
Requries entering password when system on boot.
Disable this function. (Default value)
Enable Start from floppy. (Default value)
Disable this device.
Enable Start from IDE HDD. (Default value)
Disable this device.
6 2