Table of Contents
Advertisement
Security
About This Section: Security
In this section, user can set either supervisor or user passwords, or both for different level of
password securities. In addition, user also can set the virus protection for boot sector.
Main
Advanced
Supervisor Password Is:
User Password Is:
Set Supervisor Password
Set User Password
Password On Boot
TPM Support
F1
Help
Select Item
Esc
Exit
Select Menu
Set Supervisor Password
You can install and change this options for the setup menus. Type the password up to 6
characters in lengh and press <Enter>. The password typed now will clear any previously
entered password from the CMOS memory. You will be asked to confirm the entered
password. Type the password again and press <Enter>. You may also press <Esc> to abort
the selection and not enter a specified password or press <Enter> key to disable this option.
Set User Password
You can only enter but do not have the right to change the options of the setup menus. When
you select this function, the following message will appear at the center of the screen to assist
you in creating a password.
Type the password up to 6 characters in lengh and press <Enter>. The password typed now
will clear any previously entered password from the CMOS memory. You will be asked to
confirm the entered password. Type the password again and press <Enter>. You may also
press <Esc> to abort the selection and not enter a specified password.
PhoenixBIOS Setup Utility
Security
Clear
Clear
[Enter]
[Enter]
[Disabled]
[Enabled]
+/-
Change Values
Enter
Select Sub-Menu
Figure 3: Security
4 6
TPM State
Boot
Item Help
F9
Setup Defaults
F10
Save and Exit
BIOS Setup
Exit
Advertisement
Table of Contents
