Onboard Parallel Port; Parallel Port Mode; Ecp Mode Use Dma - Biostar GF7100P-M7S Manual

Bios setup

Hide thumbs Also See for GF7100P-M7S:

Table of Contents

GF7100P-M7S

Onboard Parallel Port

This item allows you to determine access onboard parallel port controller with

which I/O Address.

The Choices: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.

This item allows you to determine how the parallel port should function. The

default value is SPP.

The Choices:

SPP (default)

EPP

ECP

ECP+EPP

Select a DMA Channel for the port.

The Choices: 3 (default), 1.

PWRON After PWR-Fail

This setting specifies how your system should behave after a power fail or

interrupts occurs. By choosing off will leave the computer in the power off state.

Choosing On will reboot the computer. Former-Sts will restore the system to the

status before power failure or interrupt occurs.

The Choices: Off (default), On, Former-Sts.

Using Parallel port as Standard Printer Port.

Using Parallel Port as Enhanced Parallel Port.

Using Parallel port as Extended Capabilities Port.

Using Parallel port as ECP & EPP mode.

Table of Contents