Using Static Routes; Static Route Example - NETGEAR DG834Gv4 - 54 Mbps Wireless ADSL Firewall Modem Reference Manual

6. Fill in the Host Name, User Name, and Password fields.
The dynamic DNS service provider may call the host name a domain name. If your URL is
myName.dyndns.org, then your host name is myName. The password can be a key for your
dynamic DNS account.
7. If your dynamic DNS provider allows the use of wildcards in resolving your URL, you can
select the Use wildcards check box to activate this feature.
For example, the wildcard feature will cause *.yourhost.dyndns.org to be aliased to the same
IP address as yourhost.dyndns.org.
8. Click Apply to save your configuration.

Using Static Routes

Static routes provide additional routing information to your router. Under normal circumstances,
the router has adequate routing information after it has been configured for Internet access, and
you do not need to configure additional static routes. You must configure static routes only for
unusual cases such as multiple routers or multiple IP subnets located on your network.

Static Route Example

As an example of when a static route is needed, consider the following case:
• Your primary Internet access is through a cable modem to an ISP.
• You have an ISDN router on your home network for connecting to the company where you are
employed. This router's address on your LAN is 192.168.0.100.
• Your company's network is 134.177.0.0.
When you first configured your router, two implicit static routes were created. A default route was
created with your ISP as the modem router, and a second static route was created to your local
network for all 192.168.0.x addresses. With this configuration, if you attempt to access a device on
the 134.177.0.0 network, your router forwards your request to the ISP. The ISP forwards your
request to the company where you are employed, and the request is likely to be denied by the
company's firewall.
In this case you must define a static route, telling your router that 134.177.0.0 should be accessed
through the ISDN router at 192.168.0.100. The static route would look like
Advanced Configuration
ADSL2+ Modem Wireless Router DG834G Reference Manual
v2.0, September 2007
Figure 5-5.
5-9