Table of Contents
Advertisement
setting is only available if you have defined internet call
service settings.
Reject call with message
•
text message to the caller.
Message text
•
is sent when you reject a call.
Own video in recvd. call
•
sending during a video call from your device.
Image in video call
•
not sent during a video call.
Automatic redial
•
maximum of 10 attempts to connect the call after an
unsuccessful call attempt. To stop automatic redialling,
press the end key.
Show call duration
•
during the call.
Summary after call
•
the call.
Speed dialling
•
Anykey answer
•
Line in use
— This setting (network service) is shown
•
only if the SIM card supports two subscriber numbers,
that is, two phone lines. Select which phone line you
want to use for making calls and sending text
messages. Calls on both lines can be answered
irrespective of the selected line. If you select
have not subscribed to this network service, you are not
able to make calls. When line 2 is selected,
displayed in the home screen.
Line change
— Prevent line selection (network
•
service), if supported by your SIM card. To change this
setting, you need the PIN2 code.
Noise cancellation
•
116
cancellation.
— Reject a call, and send a
— Write the standard text message that
— Allow or deny video
— Display a still image if video is
— Set your device to make a
— Display the length of a call
— Display the length of a call after
— Activate speed dialling.
— Activate anykey answer.
— Activate earpiece active noise
Contact search
•
screen.
Network settings
Select
Menu
Network.
To select the network mode, select
Dual
mode, UMTS, or GSM. In dual mode, the device
switches automatically between networks.
Tip: Selecting
but may increase the demand on battery power and
reduce the battery life. In regions close to both GSM
and UMTS networks, selecting
cause constant jumping between the two networks,
which also increases the demand on battery power.
To select the operator, select
Manual
to select from available networks, or
to set the device to select the network automatically.
To set the device to indicate when it is used in a
microcellular network (MCN), select
On.
Connection settings
Line 2
and
is
Select
Menu
Select from the following:
Bluetooth
•
USB
— Edit the data cable settings.
•
Destinations
•
points. Some or all access points may be preset for your
— Activate contact search in the home
Ctrl. panel
Settings
>
>
Network mode
UMTS
enables faster data transfer,
Dual mode
Operator selection
Cell info display
Ctrl. panel
Settings
>
>
— Edit the Bluetooth settings.
— Set up new or edit existing access
and
Phone
>
and
may
and
Automatic
>
and Connection.
Advertisement
Table of Contents
