Active Data Connections - Nokia 002L5G7 User Manual

EAP plug-in settings
●
your service provider.
Pre-shared key
●
on the WLAN access point device.
WPA2 only mode
●
connection in this mode.
Advanced WLAN settings
Select Options
>
IPv4 settings
●
default gateway, and the IP addresses of the primary and secondary DNS servers.
Contact your internet service provider for these addresses.
IPv6 settings
●
Ad-hoc channel
●
manually, select
Proxy server address
●
Proxy port number
●

Active data connections

Select Menu Settings
>
In the active data connections view, you can see the open data connections:
data calls
packet data connections
wireless LAN (WLAN) connections
Note: The actual invoice for calls and services from your service provider
may vary, depending on network features, rounding off for billing, taxes, and so
forth.
To end a connection, select
To end all open connections, select
© 2009 Nokia. All rights reserved.
— Enter the settings according to the instructions from
— Enter a password. The same password must be entered
— Only WPA2 enabled devices are allowed to establish a
Advanced settings
— Enter the IP address of your device, the subnet IP address, the
— Define the type of DNS address.
(only for Ad-hoc) — To enter a channel number (1-11)
User defined.
— Enter the address for the proxy server.
— Enter the proxy port number.
and Connectivity
Options
and from the following:
Connection
>
> Disconnect.
Options Disconnect
>
Connectivity
mgr..
all.
111