Download Print this page

HWM DXmic User Manual page 10

Advertisement

The battery pack for the DXmic is supplied within the control unit.
Battery charging
To charge the batteries, lift the rubber connector cover cap the charge lead from the charger to
the battery charging connector on the top of the DXmic. Plug the charger unit into the mains
supply.
Note that the battery will not charge through the USB port.
While the batteries are charging with the device in standby, the charging LED on the front of the
DXmic will be flashing red. The LED will flash green when the batteries are fully charged. The
time required to charge the batteries from flat is approximately 8 hours.
The On/Off switch can be pressed while the unit is on charge to see how much charge is in the
batteries at any time. When fully charged the battery, icon located in the top right corner of the
screen will appear completely dark.
Firmly push the rubber connector cover back into position to protect the connectors when not in
use.
NOTE: You can only charge the DXmic between 0°C - 45°C.
In-case charging
It is possible to charge both DXmic and Bluetooth headphones while safely stored in the case
using the internal cable system.
USB socket for
Bluetooth headphones
charger
Preparing the DXmic for Use
DC plug for DXmic
Page 9 of 35

Advertisement

loading
Need help?

Need help?

Do you have a question about the DXmic and is the answer not in the manual?