Related Manuals for Lofra HDS9T0
Summary of Contents for Lofra HDS9T0
- Page 1 INSTRUCTIONS FOR THE INSTALLATION AND USE OF BUILT-IN HOT PLATES COD. 208599-00 - 29.07.2014...
-
Page 2: General Notice
Dear Customer, We thank you and congratulate you on granting us your preference, by purchasin one of our products. We are sure that this new appliance, manufactured with quality materials, will meet your requirements in the best possible way. The use of this new equipment is easy. However, we invite you to read this booklet carefully, before installing and using the appliance. -
Page 3: Instructions For The User
INSTRUCTIONS FOR THE USER It is necessary that all the operations regarding the installation, adjustment and adaptation to the type of gas available are carried out by qualified personnel, in conformity with the regulations in force. The specific instructions are described in the booklet section intended for the installer. -
Page 4: Instructions For The Installer
INSTRUCTIONS FOR THE INSTALLER IMPORTANT NOTICE: THE OPERATIONS INDICATED BELOW MUST BE FOLLOWED BY QUALIFIED PERSONNEL EXCLUSIVELY, IN CONFORMITY WITH THE REGULATIONS IN FORCE. THE MANUFACTURING FIRM REFUSES ALL RESPONSIBILITY FOR DAMAGES TO PEOPLE, ANIMALS OR THINGS, RESULTING FROM THE FAILURE TO COMPLY WITH SUCH PROVISIONS. INSTALLATION Fastening the top Every cook-top is equipped with a special washer. - Page 5 INSTRUCTIONS FOR THE INSTALLER Gas connection Adjusting the burners Make sure that the appliance is adjusted for The lowest flame point must always be properly the gas type available (see the label under the adjusted and the flame must remain on even if appliance).
- Page 6 Closed Maximum Minimum 10/A...
- Page 7 600 mm HOBS 750 mm HOBS 900 mm HOBS 1 Rapid burner 3000 W 2 Semi-rapid burner 1750 W 3 Auxiliary burner 1000 W 4 Triple ring burner 3800 W 8 Control knob for burner...
-
Page 8: Technical Characteristic Tables
TECHNICAL CHARACTERISTIC TABLES NOMINAL TAPE BY NORMAL NOMINAL INJECTOR BURNERS HEAT INPUT PASS PRESSURE RATE DIAMETER DIAMETER 1/100 N° mbar 1/100 mm Max. Min. DESCRIPTION G30/G31 28 - 30 / 37 3000 RAPID 115Y Reg. 3000 G30/G31 28 - 30 / 37 1750 SEMI-RAPID Reg. - Page 9 3000 G30/G31 3000 Reg. 1750 G30/G31 1750 Reg. 1000 G30/G31 1000 Reg. 2100 3800 G30/G31 2100 3800 Reg. 2002/96/EC...
- Page 11 10/A...
- Page 12 " " H05VV-F 0.75 × H05RR-F –...
- Page 13 – – – FOR THE U.K. ONLY The room containing this hotplate should have an air supply in accordance with BS 5440: Part 2: 1989. All rooms require an openable window, or --equivalent and some rooms will require a permanent vent a well. For room volumes up to 5 m-- an air vent of 100cm required.
- Page 14 – – – – 1000 – 1750 – 3000 – 3800 –...
- Page 15 EEC 90/396 EEC 2004/108/CE 2006/95/CE EEC 89/109...
- Page 16 2014-03-31 – 0 – 208599...
Need help?
Do you have a question about the HDS9T0 and is the answer not in the manual?
Questions and answers