Extension Cords; Operating Instructions - Delta 22-540 Instruction Manual

Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord which
has a 3-prong grounding type plug and a 3-hole receptacle which will accept the tool's plug. When using an extension
cord, be sure to use one heavy enough to carry the current of the saw. An undersized cord will cause a drop in line
voltage, resulting in loss of power and overheating. Fig. DD, shows the correct gauge to use depending on the cord
length. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.
MINIMUM GAUGE EXTENSION CORD
RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC TOOLS
Ampere Volts Total Length of
Rating Cord in Feet
0-6 120 up to 25
0-6 120 25-50
0-6 120 50-100
0-6 120 100-150
6-10 120 up to 25
6-10 120 25-50
6-10 120 50-100
6-10 120 100-150
10-12 120 up to 25
10-12 120 25-50
10-12 120 50-100
10-12 120 100-150
12-16 120 up to 25
12-16 120 25-50
12-16 120
GREATER THAN 50 FEET NOT RECOMMENDED
Fig. DD

OPERATING INSTRUCTIONS

FOREWORD
Delta Model 22-540 is a 12" (305mm) Portable Planer with adjustable feed rate for optimum planing under load. It has
the following cutting capacity; 12" (305mm) width , 6" (152mm) thickness and 3/16" (5mm) depth of cut. Features include;
basic machine with powerful 15 amp, 120 volt motor, dust chute, two-knife cutterhead with an extra set of high-speed
steel, double-edged reversible knives; knife-setting gage and wrench, polyurethane feed rolls and adjustable-folding
table extensions.

EXTENSION CORDS

Gauge of
Extension Cord
18 AWG
16 AWG
16 AWG
14 AWG
18 AWG
16 AWG
14 AWG
12 AWG
16 AWG
16 AWG
14 AWG
12 AWG
14 AWG
12 AWG
5
MINIMUM GAUGE EXTENSION CORD
RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC TOOLS
Ampere Volts Total Length of
Rating Cord in Feet
0-6 240 up to 50
0-6 240 50-100
0-6 240 100-200
0-6 240 200-300
6-10 240 up to 50
6-10 240 50-100
6-10 240 100-200
6-10 240 200-300
10-12 240 up to 50
10-12 240 50-100
10-12 240 100-200
10-12 240 200-300
12-16 240 up to 50
12-16 240 50-100
12-16 240
GREATER THAN 100 FEET NOT RECOMMENDED
Fig. DD
Gauge of
Extension Cord
18 AWG
16 AWG
16 AWG
14 AWG
18 AWG
16 AWG
14 AWG
12 AWG
16 AWG
16 AWG
14 AWG
12 AWG
14 AWG
12 AWG