Spectris Arcom VIPER Quick Start Manual page 16

VIPER RedBoot and AEL Quickstart
Booting the system
Once the system has been connected and powered up (as described in
connecting
Uncompressing Linux................. done, booting the kernel.
...
CPU: XScale−PXA255 [69052d06] revision 6 (ARMv5TE)
...
Machine: Arcom VIPER SBC
Memory policy: ECC disabled, Data cache writeback
Memory clock: 99.53MHz (*27)
Run Mode clock: 398.13MHz (*4)
Turbo Mode clock: 398.13MHz (*1.0, active)
Built 1 zonelists
Kernel command line: root=/dev/mtdblock2 rootfstype=jffs2 ro
console=ttyS0,115200
...
3 RedBoot partitions found on MTD device flash
Creating 3 MTD partitions on "flash":
0x00000000−0x0001f000 : "FIS directory"
0x0001f000−0x00020000 : "RedBoot config"
0x00020000−0x02000000 : "filesystem"
...
INIT: version 2.85 booting
...
Configuring network interfaces...
If you do not have a DHCP server and you have not configured a static IP
address, the board pauses at this point while it searches for a DHCP server. See
Setting up
... done.
...
INIT: Entering runlevel: 3
Starting system log daemon: syslogd.
Starting hotplug subsystem:.... already started. process pending
events.
Starting kernel log daemon: klogd.
Starting NFS common utilities: statd.
Loading /etc/console/keymap.gz
Starting PCMCIA services: done.
Starting internet superserver: inetd.
Starting http server: thttpd.
Starting OpenBSD Secure Shell Server: sshd.
Starting periodic command scheduler: cron.
Arcom Embedded Linux (ttyS0)
viper login:
© 2005 Arcom Issue D
up, page 10) the board automatically boots to a Linux prompt, as follows:
networking, page 18.
Arcom Embedded Linux (AEL)
Unpacking and
16