Canarm CP80L Operation Instructions And Parts Manual

Ultra quiet high performance exhaust fans

Advertisement

Available languages

Available languages

Quick Links

CP80L
ULTRA QUIET HIGH
PERFORMANCE EXHAUST FANS
OPERATION INSTRUCTIONS AND PARTS MANUAL
PLEASE READ AND SAVE THESE INSTRUCTIONS
OPERATION INSTRUCTIONS AND PARTS MANUAL
PLEASE READ AND SAVE THESE INSTRUCTIONS
MODELS: CP80L
The purpose of this manual is to aid in the proper installation and operation of the CP Series exhaust fans. These instructions are intended
to supplement good general practices and are not intended to overwrite local codes and ordinances.
IT IS THE RESPONSIBILITY OF THE PURCHASER TO ENSURE THAT THE INSTALLATION AND MAINTENANCE OF THIS
EQUIPMENT IS HANDLED BY QUALIFIED PERSONNEL.
Inspect all shipments carefully for damage. THE RECEIVER MUST NOTE ANY DAMAGE ON THE CARRIER'S BILL OF LADING AND
FILE A CLAIM IMMEDIATELY WITH THE FREIGHT COMPANY.
GENERAL SAFETY
1.
Use this unit only in the manner intended by the manufacturer. If you have questions,
contact the manufacturer at the address or telephone number listed in the warranty.
2.
Before servicing or cleaning unit, switch power off at service panel and lock the service
disconnecting means to prevent power from being switching on accidentally. When the
service disconnecting means cannot be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
3.
Installation work and electrical wiring must be done by a qualified person(s) in accordance
with all applicable codes and standards, including fire-rated construction codes and
standards.
4.
Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to
prevent backdrafting. Follow the heating equipment manufacturer's guideline and safety standards such as those published by the
National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
5.
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
6.
Ducted fans must always be vented to the outdoors.
7.
Acceptable for use over a tub or shower when connected to a GFCI (Ground Fault Circuit Interrupter) - protected branch circuit.
8.
This unit must be grounded.
9.
For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors.
10.
This product is designed for installation in ceilings up to a 12/12 pitch (45 degree angle). Duct connector must point up.
11.
To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall spray, construction dust, etc. off power unit.
12.
Please read specification label on product for further information and requirements.
Please follow all applicable national, state/provincial and local codes. All of them will supersede this manual.
13.
14.
Failure to follow the safety instructions in this manual may cause serious injury or death due to electrical shock or high
speed rotating parts.
CLEANING AND MAINTENANCE
For quiet and efficient operation, long life, and attractive appearance - lower or remove grille and vacuum interior of unit with the dusting
brush attachment.
M-CP80L 11/24
Page 1 of 6

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CP80L and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Canarm CP80L

  • Page 1 OPERATION INSTRUCTIONS AND PARTS MANUAL PLEASE READ AND SAVE THESE INSTRUCTIONS MODELS: CP80L The purpose of this manual is to aid in the proper installation and operation of the CP Series exhaust fans. These instructions are intended to supplement good general practices and are not intended to overwrite local codes and ordinances.
  • Page 2: Operation

    Hold the housing so that it is in contact with the bottom of the joist. b. Attach the housing with four (4) screws to the joist through the holes in each mounting flange. M-CP80L 11/24 Page 2 of 6...
  • Page 3 Screw or nail the fan housing directly to the framing or joists. Remove the blower assembly as directed in the service parts section of this manual to gain access to the additional mounting holes. additional mounting holes M-CP80L 11/24 Page 3 of 6...
  • Page 4: Electrical Wiring Connection

    Refer to the wiring diagram, and connect the wires as shown. BLACK(BLK) WHITE(WHT) BLUE(BLU) GROUND (GRD) LIGHT LIGHT SWITCH WIRE UNIT LIGHT PANEL RECEPTACLE SWITCH LINE LIGHT SWITCH BOX RECEPTACLE SWITCH BOX UNIT POWER SUPPLY 120V AC M-CP80L 11/24 Page 4 of 6...
  • Page 5: Grille Installation

    WARRANTY CANARM Ltd. warrants every new fan to be free of defects in material and workmanship to the extent that, within a period of one year from the date of purchase CANARM Ltd. shall either repair or replace at CANARM’s option, any unit or part thereof, returned freight prepaid and found to be defective.
  • Page 6 MODE D’OPÉRATION LIRE ET GARDER CES INSTRUCTIONS MODÈLES: CP80L Ce manuel a pour objectif de fournir un guide pour l'installation et l'utilisation correcte du ventilateur d'extraction de la série CP. Ces instructions sont destinées à compléter les bonnes pratiques générales et ne sont pas destinées à remplacer les normes et codes locaux.
  • Page 7: Opération

    Maintenez le boîtier de manière à ce qu’il soit en contact avec le bas de la solive. b. Fixez le boîtier avec quatre (4) vis à la solive à travers les trous de chaque bride de montage. M-CP80L 11/24 Page 2 de 6...
  • Page 8 Vissez ou clouez le boîtier du ventilateur directement sur la charpente ou les solives. Retirez l'ensemble du ventilateur comme indiqué dans la section Pièces de rechange de ce manuel pour accéder aux trous de montage supplémentaires. trous de montage supplémentaires additional mounting holes M-CP80L 11/24 Page 3 de 6...
  • Page 9 PANNEAU DE FIL interrupteur noire de ventilateur ventilateur PRISE DE VENTILATEUR blanc ventilateur noire ligne blanc dans fil de terre boîte de RÉCEPTACLE commutation DE LUMIÈRE boîte de ventilateur ALIMENTATION commutation ÉLECTRIQUE 120V AC M-CP80L 11/24 Page 4 de 6...
  • Page 10: Installation De La Grille

    CANARM LTD. Garantie que chaque nouveau ventilateur est exempt de défauts matériels et de fabrication dans la mesure où, dans un délai d’un an à compter de la date d’achat, CANARM Ltd. réparera ou remplacera, au choix de Canarm, toute unité ou pièce de celle-ci, retourné...

Table of Contents