Removing Mapsource; Connecting Your Gps Unit To A Computer - Garmin 010-10307-00 - MapSource Fishing Hot Spots User Manual

I M s > c
nstallIng ap ource

Removing MapSource

You can remove any MapSource product from your
computer without using the MapSource installation
disks.
To remove MapSource:
1. Click the Start button. Then select
Control Panel.
2. Select Add/Remove
3. Highlight MapSource and click Change/
Remove.
4. Follow the instructions to remove MapSource.
OR
1. Click the Start button. Then select Programs
> MapSource >
Installation Wizard (if enabled).
2. Click Next.
3. Select Remove.
NOTE: To completely remove MapSource, you
must also delete the C:\Garmin\USB_Drivers
directory from your computer

r M
hangIng or eMovIng
Settings
Programs.
MapSource product
.
s
ap ource
Connecting Your GPS Unit to a
Computer
Install your MapSource software or run the installation
disk for your product before you connect your GPS
unit to your computer. If your MapSource product
came with a setup guide, follow those instructions to
>
learn how and when to connect your GPS unit to your
computer. You can also find this information in your
GPS unit owner's manual.
To connect your GPS unit to your computer:
1. If your GPS unit came with a PC Interface
Cable, connect your GPS to a serial
communications port on your computer (see
illustration below).
Serial Communications Port
MapSource User's Manual