Sending Data To Your Gps Unit - Garmin 010-10307-00 - MapSource Fishing Hot Spots User Manual

u M s > t
sIng ap ource ransferrIng

Sending Data to Your GPS Unit

If your GPS unit has a storage card, verify that the card
is inserted correctly into the unit. Also, connect your
GPS unit to your computer and set your unit's Data
Transfer mode to Garmin, if applicable (see your unit
owner's manual for instructions).
You can send maps, waypoints, routes, or tracks to
your GPS unit.
NOTE: MapSource transfers all of the data listed
in a data tab to your GPS unit each time you
transfer data.
To send data to a GPS unit or card reader:
1. Verify that the data you want to send appears in
the corresponding data tabs on the left side of
the MapSource window.
2. Click Send To Device
Send To Device.... The name of your GPS unit
or card reader should appear automatically in
the Device menu. If not, click Find

M s d
ap ource ata
or click Transfer >
Device.
• If you are using a USB card programmer,
"USB Data Card Programmer" appears in
the Device field.
• If you are using a CF or SD card reader,
select the correct drive letter from
the Device field. For example, select
"Removable Disk (E:)."
• If you are sending data to an iQue or cf
Que, select where you want to save data
under Map Storage Location. If necessary,
select the correct user name from the
Device fields.
3. Under What to Send, check the boxes next to
each type of data you want to send.
4. Click Send. MapSource begins sending data to
your GPS unit or card reader. After you begin
transferring data, you can check the box next to
Turn Off GPS After
5. If you are using an iQue or cf Que, synchronize
with your personal computer, if necessary, so
that your unit receives the data.
Transfer, if available.
MapSource User's Manual