Download Print this page
Davey DC10 Installation And Operating Instructions
Davey DC10 Installation And Operating Instructions

Davey DC10 Installation And Operating Instructions

Advertisement

Quick Links

Sump Pump
Installation and Operating
DOUBLE CASED:
DEWATERING:
VORTEX:
TWIN IMPELLER: D42, D53
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
CAUTION: This pump MUST be installed with a suitable earth leakage circuit breaker (E.L.C.B.) or
residual current device (R.C.D.) with a rated residual operating current <30mA.
The oil in the seal chamber should be periodically checked and replaced. This work should
be done by a suitably qualified Davey Service Dealer every 2,000hrs of operation or every 12
months, whichever occurs first.
Please pass these instructions on to the operator of this equipment.
Instructions
Models:
DC10, DCS40, RS250, RSD400
D10, D15, D25, D40
D15V, D25V, D40V
Suffix: A = Automatic Float Switch Fitted
M = Manual (D75 Models only)
Voltage: 220/250V 50Hz Single Phase

Advertisement

loading
Need help?

Need help?

Do you have a question about the DC10 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Davey DC10

  • Page 1 (R.C.D.) with a rated residual operating current <30mA. The oil in the seal chamber should be periodically checked and replaced. This work should be done by a suitably qualified Davey Service Dealer every 2,000hrs of operation or every 12 months, whichever occurs first.
  • Page 2 If you are unsure as to the suitability of the fluids, contact your Davey dealer for advice. NOTE: If the cord is damaged, the The multi impeller D42 & D53 are designed for clean appliance should be repaired by water only.
  • Page 3 Pump operating in non submerged position or be open to the atmosphere.  with no water movement around motor 5. ALWAYS disconnect pump from (not applicable to DC10). power supply prior to commencing Electrical fault.  ANY maintenance or adjustment.
  • Page 4 Email: sales@dwp.co.nz ® Davey is a registered trademark of Davey Water Products Pty Ltd. © Davey Water Products Pty Ltd 2020. P/N 48172-9 * Installation and operating instructions are included with the product when purchased new. They may also be found on our website.

This manual is also suitable for:

Dcs40Rs250Rsd400D10D15D25 ... Show all