Voltage Selector Switch - YORKVILLE YX15P Owner's Manual

set the volume for the enclosure. If there are
multiple YX15P enclosures in a system, it will be
necessary to set the Levels separately. If using
a mixer for the line source, the mixer should
control the level of all the YX15P enclosures.
(When a mixer drives the YX15P enclosures,
the Level control should be set to maximum). If
there are multiple YX15P enclosures it may be
desirable to set the level control of individual
enclosures to less than maximum (if it's
desirable for that enclosure to be quieter).
Treble, Mid and
Bass Controls
These controls affect all
the sound coming out
of a particular YX15P
enclosure. These controls
do not affect the sound
at the Mix Out. In a system
with multiple cabinets it
will be necessary to adjust
the bass, Treble, Mid
and Bass controls on all
individual enclosures.
Signal / Limit LED
This dual LED illuminates
green when signal is present
and red when limiting.
MIX OUT
2
Mic Gain
Mic In
Line In
Mix Out
Shield
Signal Limit
Power
YX SERIES
YX15P
3
1 2
200 WATT BI-AMP POWERED
LOUDSPEAKER ENCLOSURE
MIC IN MIC GAIN
3
1 2
LINE IN
Shield
LEVEL
3
2 1
Shield Switch
The Shield switch disconnects the ground
connection on the Line In. This may help prevent
hum or buzz under some circumstances.
Power LED and Switch
The Power Switch turns the power on and
off for the YX15P enclosure, the green LED
will illuminate when the power is on also
indicating a properly functioning fuse.
Voltage Selector
Switch
Select the proper voltage
for the geographical region
min max
in which the YX15P will
be used. The unit is set for
Treble
115V when used with the
standard North American
- 6 + 6
dB
Mid
line voltage. For European
operation set the unit to
- 6 + 6
dB 230V. If in doubt of the line
Bass
voltage please contact your
local Yorkville dealer.
- 6 + 6
dB
Level
- 00 0
dB
Power
5kHz
20 WATTS
TONE CONTROLS
30hz/5kHz
180 WATTS
YX SERIES