ITech IT6000 Series User Manual page 12

Note: The maximum current of the positive and negative terminals of IN
and OUT on the rear panel is 1000A.
3. Normally open contact
4. Digital IO terminals
1.2 How to Use
For battery testing applications, refer to the following steps.
1.
2.
5A at 250VAC, 24VDC
When leaving the factory, the pin IN is shorted to GND by default, and the
instrument can work normally; if the short-circuit piece is removed, the
instrument will not work. When the instrument is running, there is a low level
of 0V between OUT and GND, and a high level of 5V in the non-RUN state.
Make sure that the power of the battery, IT-E165A, and IT6000 is turned
off.
Refer to the following diagram to connect the IT6000 series instrument and
the DUT (battery).
IT-E165A-250, IT-E165A-400, IT-E165A-500

Note: The green terminals Sense and IO on the rear panel are
reserved terminals and do not need to be connected.
Copyright© Itech Electronics Co., Ltd.
IT-E165A User Manual
5