Installing Your Child Seat (Rearward Facing) In Rear Side Seat - Britax MULTI-TECH Manual

2. Installing your child seat (rearward facing) in rear side seat

2a
2b
2d
2e
IMPORTANT - The child seat
seat belt (approved to UN/ECE regulation no. 16 or equivalent standards).
IMPORTANT - Do not use any load bearing contact points other than those
described in the instructions and marked in the child restraint.
DO NOT under any circumstances use a rearward facing child seat on a
passenger seat fitted with an active airbag.
With the footprop adjusted to the shortest length, place the child seat rearward
facing on the car seat with the swinging base resting against the back of the
vehicle seat. After installation the gap between the seat in front and the child seat
should ideally be a minimum of 10mm
The child seat can touch the seat in front but must not rest against it. If it does
then adjust the car seat in the front without making the driver or passenger sit in
an uncomfortable position. If not try another seating position in the car.
2c
Pull all the seat belt slack through the child seat ensuring the seat belt is not
twisted. When the belt is as tight as possible, close the lock-off on the seat belt
buckle side, ensuring that both the lap and diagonal sections of the belt are
secured by it (dia 2d inset).
Close the lock-off on the opposite side, ensuring that only the lap section of the
belt is secured by it (dia
Ensure that both lock-offs have been clicked into place.
If the buckle now lies in the position marked as wrong with a
belt cannot be correctly tightened
car.
MUST only be used with a lap or a lap and diagonal
(dia 2a).
Open both lock-offs. Pull off sufficient lap
and diagonal belt
Feed the belt through the lock-off belt
guide on the opposite side to the buckle
and in to the belt tunnel
are two access slots in the seat cover to
aid feeding of the belt through the belt
tunnel and underneath the seat cover
2b inset).
Feed the seat belt through the belt tunnel
and lock-off on the opposite side and
attach the tongue into the buckle
2d).
(dia 2e), try another seating position in the
(approx. 600-900mm).
(dia 2b). There
(dia
(dia 2c).
and the seat