Installation: Rear Facing
LATCH Installation
•
Figure A illustrates a typical rear facing
LATCH installation.
•
Verify that your vehicle is equipped
with LATCH anchors. If LATCH anchors
are not available, you must use vehicle
belt installation methods.
1
If stored, remove LATCH connectors
from storage slots under cover (pg. 25).
2
Press each LATCH adjuster release
button, then pull LATCH harness to full
length.
3
Thread each LATCH connector through
adjacent rear facing belt slot (fig. B).
Fully recline the restraint then place it
4
sideways on the vehicle seat, with the
front facing toward you.
5
Attach the farthest LATCH connector
to the farthest LATCH anchor (fig. C).
•
A positive click confirms attachment.
•
If LATCH connectors will not attach with
a positive click, it may be necessary to
switch the LATCH connectors as shown
on page 25.
Rotate seat into rear facing position.
6
7
Verify that the LATCH harness is not
twisted, then attach the closest LATCH
connector to the closest LATCH anchor
(fig. D).
10
A
B
C
8
Push the child restraint firmly into the
vehicle seat while pulling each LATCH
harness tight (fig. E).
9
Verify that all connections are secure
and the restraint is stable.
•
The restraint is tight when it cannot be
moved more than 1" (2.5 cm) at the
belt path.
•
The back angle of the child restraint
should not exceed 45º when properly
installed rear facing.
•
If there is a problem stabilizing the
restraint or achieving necessary angle,
place a tightly rolled towel in the crease
of the vehicle seat to help level the
restraint.
•
Installation can be improved by the use
of the Versa-Tether
(pgs. 21–23). The
®
recline angle can be adjusted by
tightening the tether as described on
page 22, using anchor point 3.
WARNING:
Do not raise the restraint off of the front edge of the vehicle seat;
doing so will reduce the protection for your child.
Removal
1
While pushing the restraint firmly into the vehicle seat, press the
red release button on the LATCH connector to release.
If connected, disconnect the Versa-Tether from the tether anchor.
2
3
When not in use, always store the LATCH connectors in
storage slots (pg. 25).
Installation: Rear Facing
D
E
11