Installation: Forward Facing
Lap Belt Installation
•
Figure A illustrates a typical forward
facing lap belt installation.
•
When not in use, always store the
LATCH connectors in storage slots.
Place the child restraint forward facing
1
on the vehicle seat.
•
Restraint must be in the full upright
position when installed in forward facing
mode with children over 33 pounds (15kg).
•
If using Versa-Tether
, remove from
®
pouch and loosely attach to an approved
tether anchorage point (pg. 22).
Pull the vehicle belt out then thread it
2
through the forward facing belt path.
(fig. A).
3
Verify that the vehicle belt is not
twisted, then buckle (fig. B).
Kneel on the child restraint to force it
4
into the vehicle seat while removing
slack from the vehicle belt (fig. C).
5
Verify that the vehicle belt is tight and
the child restraint is secure.
•
The restraint is tight when it cannot be
moved more than 1" (2.5 cm) at the
belt path.
•
Installation can be improved by the use
of the Versa-Tether
(pgs. 21–22).
®
20
A
B
C
WARNING:
WHEN USING THE RESTRAINT IN FORWARD FACING
•
MODE, ATTACH THE VERSA-TETHER ONLY TO TETHER
ANCHORS IDENTIFIED BY THE VEHICLE MANUFACTURER AS
TETHER ANCHORAGE POINTS. USE OF OTHER LOCATIONS
IS NOT APPROVED OR PERMITTED.
If a tether anchorage is not available, DO NOT modify the
•
vehicle without advice from the vehicle manufacturer.
DO NOT hook the Versa-Tether to the bottom of a vehicle
•
seat adjuster!
IMPORTANT:
Britax
®
recommends that the tether be used at all times. Using
•
the tether will improve the stability of the child restraint and
reduce the risk of injury.
If the vehicle does not currently have a tether anchor
•
attachment, refer to the vehicle owner's manual or contact
the vehicle manufacturer for assistance.
The back angle of the child restraint should be 45º–45º from
•
vertical when properly installed in the rear facing position.
NOTE:
The rear facing recline angle can be adjusted by tightening the
•
tether as described on page 24, using anchor point 3.
It may be necessary to loosen the tether and vehicle seat belt
•
before adjusting the recline position.
Installation: Versa-Tether
®
21