Blue Torrent MyBot Instructions Manual page 14

If CLEANER fails to pick up fine or heavy debris:
• Clean the filter buckets. It may be clogged. A filter cleaning solution can be used to
remove excessive dirt and/or sand.
If CLEANER starts working momentarily but then stops working:
• Impeller may be clogged or jammed with debris. Check and clean if necessary
following the instructions in the maintenance section.
• Drive tracks are stuck. Check for debris and clean if necessary.
• Cleaner performs by both timing and a pool wall detection sensor, whichever
comes first.
• There are 2 inlets located at bottom of the cleaner and near the brushes. Inlets
located next to the brushes help collect debris such as leaves and sand better than
single inlet.
• For the cleaners used in areas that have a lot of sand the cleaner may need to be
rinsed with water at the main body base and may need rinsing at the cover and
outlet to allow free operation.
• During the normal operating cycle of the cleaner, the unit will rise to allow the unit to
clear obstacles, such as elevated main drains and stair steps.
If a cleaner has poor coverage of the pool in one cycle or only covers a small area,
check the filter and clean if necessary and make sure the unit is not getting caught on
drains, floor cleaning heads or toys. The user may try starting the cleaner in different
locations to find the optimum cleaning location.
If debris falls from cleaner while removing from pool, it may be caused by filter
overload, increase frequency of filter cleaning. Assure that there is no large debris
blocking any of the two inlets. Large debris must be removed from the pool before
using machine. If drain flaps are out of place or stuck by sand or leaves in the open
position, the flaps can be snapped back into place, after cleaning the area.
Avoid dropping or throwing machine into pool. Place cleaner away from the pool wall
but do not throw the cleaner in the pool.
If the location cord gets twisted which can be caused by the cleaner working for too
long time, it can be straightened by laying the location cord at full length if possible in
the sun; heat from the sun will help reduce the twisting.
If a high level of debris is visible through the outlet, remove cleaner quickly from the
water to reduce the chance of the debris escaping the filter bag and reentering
the pool.
IMPORTANT SAFETY INSTRUCTIONS
The automatic swimming pool vacuum cleaner has been manufactured with the
highest degree of care and concern for safety. We suggest the following safety
precautions become part of your pool safety regulations:
14
TROUBLESHOOTING