Tineco FLOOR ONE S7 STEAM Series Instruction Manual
Smart cordless steam floor washer
Hide thumbs
Also See for FLOOR ONE S7 STEAM Series:
- User manual ,
- Instruction manual (272 pages) ,
- Instruction manual (21 pages)
Subscribe to Our Youtube Channel
Related Manuals for Tineco FLOOR ONE S7 STEAM Series
Summary of Contents for Tineco FLOOR ONE S7 STEAM Series
- Page 1 FLOOR ONE S7 STEAM SERIES Smart Cordless Steam Floor Washer Instruction Manual *Actual product may differ from illustration.
-
Page 3: Table Of Contents
CONTENTS Important Safety Instructions ............... 3 Specifications ..................6 Overview ....................7 Accessories .................... 9 Assembly ..................... 10 Operation .................... 11 Maintenance ..................16 Troubleshooting .................. 20 Warranty ....................21... -
Page 4: Precautionary Measures
Precautionary measures: 1. Do not operate the hard floor washer too close to heaters, radiators or other hot surfaces. 2. Before inserting the charger into the wall, make sure your hands are dry. 3. Before turning on the hard floor washer, safely remove any large objects from the floor or cleaning surface in order to prevent damage to the filter. -
Page 5: Important Safety Instructions
Important Safety Instructions IMPORTANT! Always switch off the hard floor washer before cleaning, when not in use or attempting any maintenance task. The charger must only be connected to an AC power supply at the voltage shown on the rating label. This hard floor washer should only be used for its intended purpose as described in this instruction manual. - Page 6 14. Before using the hard floor washer, manual will void the warranty. remove any large or sharp objects from 26. Exposure to hot steam can cause scalding. the floor or cleaning surface in order to prevent damage to the filter. 27.
- Page 7 Battery use and care 1. The appliance is only to be used with the charger provided with the appliance. 2. Only charge the battery inside the washer or the charging dock. Only use the specifically designated charger to charge the product. 3.
-
Page 8: Specifications
Specifications Product FLOOR ONE S7 STEAM SERIES AC Input 100-240V~ Voltage 25.2V 3900mAh Lion Rated Power 240W Running Time AUTO: 40mins,STEAM/BOOST:20mins Charging Time 4~5 hrs Water Flow Rate 20~200ml/min CWT Capacity ~0.8L DWT Capacity ~0.72L Waterproof IPX4 Symbols: Read the instruction manual... -
Page 9: Overview
Overview A. STEAM/BOOST STEAM Button K. Dirty Water Tank (DWT) B. Power On/Off L. Brush C. Digital Display M. Brush Roller Cover D. Dirty Water Tank Release N. Brush Roller E. Dirty Water Tank Handle O. Cleaning Tool F. LED Headlights P. -
Page 10: Digital Display
Digital Display E F G H I A. AUTO Mode H. Brush Roller Tangled B. Steam Making I. Boiler Error C. STEAM Mode J. Battery D. WiFi Indicator K. Battery level / Steam preparation countdown E. DWT Full L. Self-cleaning F. -
Page 11: Accessories
Accessories Note: Accessories may vary between markets. If you require more accessories, please contact Customer Service on AUS: 1800 815 270, NZ: 0800 282 288. Brush Roller Soft roller head with bristles can be used to vacuum and wash at the same time. It can be easily cleaned with the self-cleaning function. -
Page 12: Assembly
Assembly How to Assemble/Disassemble Note: For water tank and brush assembly, please refer to “Operation” and “Maintenance”. To assemble the handle, insert it into the In the event that the handle needs to be appliance until you hear a click. disassembled, press the spring to release the handle with a tool (like a screwdriver) and lift the released handle from the appliance. -
Page 13: Operation
Preparing for Use • Before first use, please charge the appliance for 4-5 hours (refer to “Charging Instructions” for details). * Based on results from Tineco lab tests. Lab temperature 39.2°F (4°C) ~ 104°F (40°C). Press the button the appliance will start... -
Page 14: Charging Instructions
Warning: • Only charge the appliance with the adaptor supplied by Tineco. • In case of long-term non use, the appliance must be charged once every 3 months for optimal performance. It may take 4-5 hours for a full charge. -
Page 15: Cleaning Mode Selection
Cleaning Mode Selection AUTO Mode • In AUTO mode, the iLoop sensor automatically detects how dirty the floor is and applies the appropriate amount of clean water and suction power accordingly. • A red dirt monitoring loop indicates pollutant intensive area, and a blue loop indicates less pollutants are detected. -
Page 16: Charging Time
• Estimated data was obtained by Tineco Laboratory under ambient temperatures between 39.2°F (4°C) to 104°F (40°C). All the functions can be performed using Tineco App. Download the app from App Store, Google Play and Tineco Official Site. Download on the... -
Page 17: Voice Prompt
(Contents may vary, please in kind prevail.) Status Reminder Voice prompts on Voice prompts enabled. Voice prompts off Voice prompts disabled. Download Tineco app and connect with Connect Tineco app appliance. Turn on the appliance Auto mode. Switch to Steam mode Steaming Mode. -
Page 18: Maintenance
Maintenance Note: • For optimal performance and odor avoidance, always clean and dry DWT, filters, brush roller, brush roller cover completely after each use. • Please make sure each part is installed correctly or the appliance may not work properly. •... -
Page 19: Dirty Water Tank
Dirty Water Tank • When dirty water reaches the Max line, the appliance then stops working, shows a remainder on the display and plays a voice prompt. • Pull up the tank lid to empty the DWT. Use the cleaning tool to remove remaining debris. Rinse the inside of the DWT and then place back into the appliance. -
Page 20: Self-Cleaning
Self-cleaning 1. Place the appliance on the charging dock after use, the sensor will auto-detect the level of dirt. 2. Press the self-cleaning button, and the appliance will select the self-cleaning mode based on the actual battery level for self-cleaning. 3. -
Page 21: Brush Roller
Brush Roller Remove the brush roller by grabbing the Use the cleaning tool to remove hair and debris brush roller tab and pulling out. wrapped around the roller and rinse the roller with water. Put the brush roller back into the accessory holder, and allow it to dry completely before reinstalling. -
Page 22: Troubleshooting
Troubleshooting Problem Possible cause Solution 1. No power 1. Charge the appliance 2. Auto protection for 2. Restart after cooling The appliance does not turn on overheating down The dry filter is not Install the dry filter or Weak suction installed, or the dry filter clean and allow it to dry is dirty... -
Page 23: Warranty
Warranty 2-YEAR LIMITED WARRANTY Your washer, in the case of domestic use, has a two year parts and labour warranty against product defects and failures when the product is used in accordance with the terms and conditions of this warranty statement. This warranty is provided by Electrical Home-Aids Pty. - Page 24 If proof of purchase cannot be provided at the time of a warranty claim or service, any work carried out on the washer is chargeable. The repair of the washer under this warranty does not extend the original period of warranty. The benefits conferred by this warranty are in addition to all other rights and remedies in respect of the product as outlined under the Competition and Consumer Act and other State and Territory laws.
- Page 28 Tineco Official Site: www.tineco.com Customer Support & Service Hotline AUS: 1800 815 270 NZ: 0800 282 288 www.godfreys.com.au www.godfreys.co.nz Distributed in Australia & New Zealand, by Electrical Home AIDS Pty Ltd (Godfreys) Brandon Office Park, Building 3, First Floor 530-540 Springvale Road, Glen Waverley VIC 3150 Australia.
Need help?
Do you have a question about the FLOOR ONE S7 STEAM Series and is the answer not in the manual?
Questions and answers