Summary of Contents for Direct Supply PAN-PL5500DF
Page 1
ATLAS FLOOR LIFTS ® Owner’s Manual Please keep and refer to this Owner’s Manual. Thank you for purchasing a Direct Supply Lift Scale from Direct Supply Equipment & ® Furnishings . Please read this entire guide carefully and keep it for future reference.
Settings Menu ........................9 Calibration & Maintenance ....................10 Limited Warranty ....................... 11 Customer Service ......................12 Introduction Thank you for purchasing a Direct Supply Lift Scale for Panacea Atlas Floor Lifts. In this ® ® owner’s manual, you’ll find important information you should read before assembling or using this product.
Floor Lifts ® ® (Models PAN-PL5500DF, PAN-PL5500DP). Do not attempt to use this scale with any other lift or for any purposes other than indicated in this manual. • WARNING: Do not install, assemble or operate this equipment without first reading and understanding the instruction manual.
Panacea Atlas ® ® Floor Lift (models PAN-PL5500DF, PAN-PL5500DP) only. This product should not be used with any other model lift. Installation 1. Remove the scale and installation hardware from the shipping carton and inspect for any signs of damage that might have taken place during shipment, such as exterior dents and scratches.
Page 6
Assembly Instructions (cont.) Assembly No Tools Required 1. Remove the cradle/spreader bar from the end of the boom (Figure 2). Keep the clevis pin and keyring on hand as they will be used to reinstall the spreader bar in Step 4. 2.
• WARNING: The membrane keyboard is not to be operated with pointed objects (pencils, pens, fingernail, etc.). Damage to the keypad from this practice will NOT be covered under warranty. The Direct Supply Lift Scale display has a membrane keypad containing three keys: ®...
Operation Operation • WARNING: Always follow safe lifting practices when weighing an individual. 1. Press the On/Off key to turn the scale display on. After power-up, the current weight will be displayed. 2. Press the Tare/Zero key to zero the value on the display, if needed. This function can be used to tare the weight of the spreader bar and sling prior to weighing the patient/resident.
Settings Menu Settings Menu To enter the Settings Menu: • When the scale is powered on and in normal operation mode, press and hold both the Hold/Unit and Tare/Zero keys for 1 second, then release. • The display will show {oFF}. This is the first setting in the menu. •...
Lift Scale has been tested and calibrated before being shipped to you. ® If your scale’s settings do not meet the requirements of your operation or if recalibration is necessary, please contact your distributor for a copy of the Direct Supply Lift Scale ®...
Limited Warranty Limited Warranty We offer to you, as the original purchaser, a warranty for the Direct Supply Lift Scale ® for Panacea Atlas Floor Lifts. Our warranty applies for the limited warranty period stated ® below. If any device or device part listed below is defective in material or workmanship during the applicable limited warranty period, we will repair or replace it at our cost.
Need help?
Do you have a question about the PAN-PL5500DF and is the answer not in the manual?
Questions and answers