Operating Your Breville Power Blender - Breville BBL300 Series Manual

Operating Your Breville Power Blender

Before first use
Remove and safely discard any packaging material and
promotional labels.
Disassemble the blender jug by following the steps in the
'Disassembling the blender' section below. Wash the lid,
inner lid, blender jug, silicon seal, blender jug base and
blade assembly in warm, soapy water with a soft cloth.
Rinse and dry thoroughly.
Wipe the motor base with a damp cloth and dry
thoroughly.
Disassembling the blender
1. Place the motor base on a flat, dry surface such as
a bench top. Ensure that the speed selection dial is
in the off '0' position, the appliance is switched off at
the power outlet and the power cord is unplugged.
2. Remove the blender jug from the motor base by
holding the motor base firmly and grasping the
blender jug handle and pulling the blender jug up
and off the motor base.
3. Remove the lid and inner measuring cup from the
blender jug.
4. Place the jug upside down on a flat, dry surface such
as a bench top.
5. Hold the jug handle and turn the blender jug base
anti-clockwise to remove. Carefully lift the blade
assembly out of the narrow end of the blender jug.
Remove the silicon seal from outside the narrow end
of the blender jug.
NOTE
The blending blades are extremely sharp. Avoid any
contact with fingers and hands.
7