Important Safety Instructions WARNING - To guard against injury, basic safety precautions should be observed, including the following: a) READ AND FOLLOW ALL SAFETY INSTRUCTIONS. b) DANGER - To avoid possible electric shock, special care should be taken since water is employed in the use of aquarium equipment.
Installation Instructions Check pump for any signs of igure shipping damage. If damaged, do not operate and return to place of purchase. 2) Insert pump onto suction cup mounting bracket (fig. A1). 3) Place pump in desired location in aquarium. 4) To install pump securely, first push in firmly on mounting bracket to allow air to be removed from suction...
Controller Settings Settings Dial: Used to select one Pump Power/Time Decrease: of the four pump modes: Decreases the amount of power to #1 Continuous Flow mode, #2 Tidal the selected pump mode, #3 Turbulence mode or #4 2) Set Button: Used to select which Turbulence/Continuous Flow mode pump to set the power level for 2) Pump 1 Indicator: Indicates the...
Programming the Controller seconds (all lights lit) and goes up A) Continuous Flow Mode: Settings DIal in 10 second intervals. Set to #1 3) Press the SET button after setting In Continuous Flow mode, the amount timer for Pump 1. Set timer for of power set for each pump will remain Pump 2 the same way as Pump 1. constant.
Light Sensor Night Mode: Using the Light Sensor igure With the Light Sensor attached, the pump will run at the setting you've programmed for it during the day, but will adjust both pumps to run continuously at 40% power when the aquarium lights are out. The Operation Indicator light will change from orange to green when in Night Mode. Plug Light Sensor into the controller. (figure B1) 2) Attach Light Sensor to top of Mounting Bracket. (figure B2) 3) Determine best location for light igure sensor—for best results place on back of tank frame under the...
Page 7
Pump Placement Tips Tidal Mode: Settings DIal Set to #2 igure To accurately simulate natural wind and tidal wave OVerHeAD VieW action, it is important to position the pumps on overflow overflow opposite ends of the aquarium, facing each other (figure C1).
Limited Lifetime Warranty WHAT THE WARRANTY COVERS: Central Aquatics (Company) warrants this Coralife product (see Exclusions below) to the original purchaser against defective material and workmanship that occurs during normal in-home use for the life of the product. Company will, at Company’s option, either repair or replace same without charge (but no cash refunds will be made).
Need help?
Do you have a question about the WAVEMAKER DC2600 and is the answer not in the manual?
Questions and answers