Wipers And Washers; Front Windshield Wipers - Hyundai Ioniq 9 Owner's Manual

convenience_features_wipers_and_washers.xml

Wipers And Washers

Front Windshield Wipers

1. Speed control knob
• HI: The wiper runs at a higher speed.
• LO: The wiper runs at a lower speed.
• AUTO: The rain sensor located on the upper end of the windshield glass senses the
amount of rainfall and controls the wiping cycle for the proper interval. The more it
rains, the faster the wiper operates. When the rain stops, the wiper stops. To vary the
speed setting, turn the speed control knob up for faster operation and down for slower
operation..
• OFF: Wipers are not in operation.
• MIST: For a single wiping cycle, push the lever downward and release. The wipers
operate continuously if the lever is held in this position.
NOTICE
• If there is heavy accumulation of snow or ice on the windshield, defrost the windshield
for about 10 minutes, or until the snow and/or ice is removed before using the
windshield wipers to ensure proper operation.
• If you do not remove the snow and/or ice before using the wiper and washer, it may
damage the wiper and washer system.
• If it snows while driving, the wiper may temporarily stop operation to prevent damage
caused by accumulated snow at the upper and lower parts of the window. When the
wiper stops operation, clear the accumulated snow from the parts.
• The wiper operation is stopped upon snow accumulation while driving. This is normal
wiper operation. It is to prevent safety issues from happening when the wiper operation
continues without removing snow.
2C_WiperSwitchOverview
Convenience Features 239